WAWEIS
WAWEIS AC Adapter for HP Omen 15-ax100 15-ax200 19.5V 7.7A 150W
150 W replacement charger for HP Omen 15-ax100 and 15-ax200 laptops with 10 ft cable and FCC, CE, RoHS certification
- World-wide 100-240 V input works anywhere
- 10 ft cord reaches distant outlets
- Over-current, over-voltage and short-circuit protection guards the laptop
- FCC, CE and RoHS certified for safety compliance
- 150 W at 19.5 V 7.7 A matches original HP Omen requirements
HP Omen 15-ax series power supply
This 150 W AC adapter is built for HP Omen 15-ax100 and 15-ax200 notebooks. It delivers 19.5 V at 7.7 A through a 10 ft cord, letting you charge or run the laptop from a wall outlet. World-wide 100-240 VAC input at 50/60 Hz means it works on mains power in most countries without a separate voltage converter.
Replaces lost or damaged original charger
Swap this unit in when the factory brick fails, goes missing or the cable frays near the connector. The jump is worth it if the old adapter no longer holds a steady 19.5 V output or if its plug wobbles in the laptop jack. FCC, CE and RoHS certifications confirm it meets the same safety baselines as the original equipment.
Steady output with built-in safeguards
Over-current, over-voltage, short-circuit and total-power protection circuits engage automatically during prolonged charging sessions. A smart chip monitors temperature and cuts power if overheating is detected, while isolation materials suppress line interference. The adapter maintains rated output continuously rather than throttling after a short burst.
Highlights
- World-wide 100-240 V input works anywhere
- 10 ft cord reaches distant outlets
- Over-current, over-voltage and short-circuit protection guards the laptop
- FCC, CE and RoHS certified for safety compliance
- 150 W at 19.5 V 7.7 A matches original HP Omen requirements
Specifications
No published specifications for this item yet.
Questions about this item
What AC input voltage range does this 150 W adapter accept for worldwide use?
It accepts 100-240 V AC at 50/60 Hz, so it works on mains supplies around the world without a voltage converter.
How do I connect the 10 ft power cord to the adapter brick and the wall outlet?
Plug the detachable mains lead into the IEC C5/C6 inlet on the brick, then insert the mains plug into a standard wall socket; the barrel tip goes into the laptop's DC jack.
Which safety certifications cover this replacement charger for long-term reliability?
The unit carries FCC, CE and RoHS certification, confirming compliance with electromagnetic, safety and hazardous-substance standards.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



