We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass electronic ball valve with 120V AC actuator, IP66 rated

Watercop EHW23AJP01 1/2" FNPT Brass Electronic Ball Valve 2-Way 120V AC IP66

SKU CH-D6V8-YRVCG

Electrically actuated 1/2" brass ball valve with IP66 protection, 600 psi rating, 120V AC operation and 2.5 second 90-degree cycle time

  • TypeHVACR and Appliance Controls
  • Automated flow control with 90-degree actuator rotation
  • Corrosion-resistant construction using chrome-plated brass ball and FKM seals
  • High-pressure capability rated for 600 psi operating pressure
  • Weatherproof IP66 enclosure protects against dust and water ingress
  • Fast 2.5-second cycle time enables rapid valve response

What This Valve Controls

The Watercop EHW23AJP01 is a two-way brass ball valve with an electric actuator for on-off service in plumbing and HVACR systems. It accepts 120V AC power and rotates 90 degrees in 2.5 seconds to open or close flow. The valve body uses a straight, two-piece design with 1/2 inch female NPT connections.

The Deciding Specification

The actuator carries an IP66 rating, meaning the motor and electronics are sealed against powerful water jets and dust ingress. If the installation site is indoors, dry and never washed down, a lower-rated actuator would also work. If the valve will be mounted outdoors, in a wash-down area or near spraying equipment, the IP66 seal is the reason to choose this model.

Behaviour Under Continuous Duty

The valve is rated for 600 psi maximum operating pressure and uses RPTFE seats with FKM seals that resist chemical attack and temperature cycling. The fail-last position holds the ball where it stopped if power is lost, so the valve does not spring open or shut during an outage. The chrome-plated brass ball and two-piece body maintain sealing integrity over repeated 90-degree cycles without the wear that soft-seated solenoid valves show after thousands of operations.

Highlights

  • Automated flow control with 90-degree actuator rotation
  • Corrosion-resistant construction using chrome-plated brass ball and FKM seals
  • High-pressure capability rated for 600 psi operating pressure
  • Weatherproof IP66 enclosure protects against dust and water ingress
  • Fast 2.5-second cycle time enables rapid valve response

Specifications

BrandWATERCOP
TypeHVACR and Appliance Controls

Questions about this item

How quickly does the valve move from fully closed to fully open once power is applied?

The actuator completes a 90-degree cycle in 2.5 seconds, so the ball rotates from shut to full flow in that time.

What does the IP66 rating actually protect the actuator against in a plant room?

IP66 means the enclosure is dust-tight and withstands powerful water jets from any direction, suitable for wash-down areas.

What pipe thread do I need on the supply side to connect this valve without adapters?

The inlet port is a 1/2-inch female NPT thread, so a matching male NPT fitting screws straight in.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.