We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Vszerda

Vszerda USB C to 4 Pin Bare Wire 11in 22AWG 3A 480Mbps 2-Pack

SKU CH-RWNV-XTNM0

An 11-inch USB-C male to 4-pin bare-wire pigtail supporting 3 A charging and 480 Mbps data for DIY repairs

  • TypeUSB
  • Connector TypeUSB Type C
  • ColorBlack
  • Connector Number4
  • Connector DetailUSB Type C
  • Terminal GenderMale-to-Male
  • Ready-to-solder tinned tails simplify DIY repairs
  • 3 A charging current powers low-voltage USB-C devices
  • 480 Mbps data rate supports file transfers
  • Colour-coded four-wire pigtail matches standard pinouts
  • 11-inch length fits tight enclosure spaces

USB C to 4 pin bare wire DIY cable

This 11 inch USB C male to 4 pin bare wire pigtail cable supports 5V 3A charging and 480 Mbps data transfer. The 22 AWG conductors are colour coded for power and data connections. It is intended for DIY repair or low power device wiring. Two cables are included in the pack.

Tinned tails simplify soldering and screw terminals

The bare wire ends are pre tinned for easier soldering or for securing under screw terminals on USB 5V power equipment. PVC insulation allows flexible routing. Correct polarity must be observed using the red positive white negative data green positive data and black ground colour code. No connectors are fitted to the bare wire end.

Suits makers repairing USB C power or data lines

Hobbyists and technicians can use this cable to replace damaged USB C leads on phones laptops lamps fans or other 5V 3A devices. It is not suitable for applications requiring higher voltage current or faster data rates. Buyers needing a finished connector on both ends or longer cable runs should look elsewhere.

Highlights

  • Ready-to-solder tinned tails simplify DIY repairs
  • 3 A charging current powers low-voltage USB-C devices
  • 480 Mbps data rate supports file transfers
  • Colour-coded four-wire pigtail matches standard pinouts
  • 11-inch length fits tight enclosure spaces

Specifications

BrandMaixbomr
TypeUSB
Connector TypeUSB Type C
ColorBlack
Connector Number4
Connector DetailUSB Type C
Terminal GenderMale-to-Male
Speed480 megabits_per_second
ConstructionPVC
FeaturesCharging 3A, Data transmission, DIY Cable

Questions about this item

How can I verify the 480 Mbps data link is active after soldering the four leads?

Connect the USB-C plug to a host and the bare wires to a device, then check the operating system reports a 480 Mbps connection and data transfers complete without errors.

What does the two-piece pack contain and what extra items are needed for installation?

The pack includes two 11-inch cables with USB-C male plugs on one end and four tinned bare wires on the other; you will need a soldering iron, heat-shrink or electrical tape, and a 5 V power source.

Which cable length should I choose for a tight enclosure repair?

The only length offered is 11 inches (30 cm), which suits compact enclosures and short-run DIY repairs.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.