We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two USB-A female to 5-pin screw terminal cables, 30 cm, PVC jacket

Vszerda

Vszerda USB 2.0 Female to 5-Pin Screw Terminal Cable 30cm 2-Pack

SKU CH-08FJ-W4VAJ

A solderless USB 2.0 female-to-5-pin screw terminal cable, 30 cm long, for extending or adapting USB connections without soldering

  • Connector TypeUSB Type A
  • Connector DetailUSB Type A
  • Solderless screw terminals simplify wiring for DIY projects
  • Shielded construction protects signal integrity during data transfer
  • 30 cm length keeps connections tidy in tight spaces
  • PVC jacket provides durable insulation for daily use
  • Two cables included for multiple devices or spares

USB 2.0 screw-terminal adapter cable

This two-pack provides a USB 2.0 Type-A female port that breaks out to a five-pin screw terminal block. It lets makers and technicians connect bare wires to USB-powered devices without soldering. The 30 cm PVC-jacketed cable adds a short, flexible extension for bench work or permanent installation. Each unit weighs 40 g and includes shielding for cleaner signal paths.

Capacity and headroom for USB 2.0 peripherals

The cable carries standard USB 2.0 data and power to devices such as smartphones, tablets, computers and televisions. It handles typical low-power peripherals and sensor wiring with ease. The screw terminals accept solid or stranded wire for secure, tool-only connections. Bandwidth and current are limited to the USB 2.0 specification, so high-speed or high-current applications will exceed its capability.

Five-pin screw terminal block decides fit

The single specification that determines compatibility is the five-way bolt-style terminal block. It provides labelled connections for VCC, D-, D+, GND and shield. Projects needing a different pin count, pitch or connector gender cannot use this adapter. The 30 cm length and Type-A female host end are fixed, so longer runs or male-host requirements need another solution.

Highlights

  • Solderless screw terminals simplify wiring for DIY projects
  • Shielded construction protects signal integrity during data transfer
  • 30 cm length keeps connections tidy in tight spaces
  • PVC jacket provides durable insulation for daily use
  • Two cables included for multiple devices or spares

Specifications

BrandYARCHONN
Connector TypeUSB Type A
Connector DetailUSB Type A

Questions about this item

Will the 30 cm cable reach from a rear motherboard USB 2.0 header to a front-panel breakout board?

The cable is 30 cm long, so measure the distance between your header and the breakout board; if the gap is shorter it will reach, otherwise you will need a longer lead.

How can I verify the shield connection is intact after wiring the five screw terminals?

Use a multimeter in continuity mode between the USB plug shell and the terminal marked for shield; a beep confirms the shielding path is complete.

Does the 2-pack include any ferrules or crimp pins for the screw terminals, or must I supply them?

The pack contains only the two PVC-jacketed cables with USB Type A plugs and 5-pin screw terminal blocks; ferrules or crimp pins are not included.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.