We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three blue SC/UPC to LC/UPC fiber adapters in a row

Vszerda

Vszerda SC/UPC Male to LC/UPC Female Single Mode 9/125µm Adapter 3-Pack

SKU CH-84TS-SRJC7

Three-pack of single-mode SC/UPC male to LC/UPC female hybrid adapters with 0.2 dB insertion loss and 50 dB return loss at 1310 nm

  • TypeFiber Optic
  • Connector NumberNo Plug
  • Low insertion loss of 0.2 dB at 1310 nm wavelength
  • High return loss of 50 dB at 1310 nm wavelength
  • Zirconia ceramic sleeve for durability and precision alignment
  • Rated for over 1000 mating cycles plug-and-play operation
  • Operates from -40 °C to 95 °C across 1310-1550 nm range

SC/UPC-to-LC/UPC hybrid adapter 3-pack

This three-pack supplies SC/UPC male to LC/UPC female adapters built for single-mode 9/125 µm fibre links. Each unit bridges equipment with mismatched connector types in test labs, LAN deployments or power-meter setups. Installers and network engineers can standardise patch panels without replacing existing cable runs.

Low-loss single-mode performance

Insertion loss measures 0.2 dB at 1310 nm while return loss reaches 50 dB across the 1310–1550 nm operating window. Zirconia ceramic sleeves maintain alignment over more than 1000 mating cycles. The assembly is rated for continuous operation from -40 °C to 95 °C with flame-retardant housing.

Ground-loop noise suppression

The adapter structure isolates ground-loop currents and rejects external interference that can distort sensitive optical measurements. This protection helps preserve signal integrity on power meters, visual fault locators and other test instruments. No software or drivers are required; the benefit is purely passive and physical.

Highlights

  • Low insertion loss of 0.2 dB at 1310 nm wavelength
  • High return loss of 50 dB at 1310 nm wavelength
  • Zirconia ceramic sleeve for durability and precision alignment
  • Rated for over 1000 mating cycles plug-and-play operation
  • Operates from -40 °C to 95 °C across 1310-1550 nm range

Specifications

BrandPoyiccot
TypeFiber Optic
Connector NumberNo Plug

Questions about this item

How do I install the SC/UPC male end into a panel, and what step is often missed?

Insert the SC/UPC male connector into the panel port until the latch clicks, then verify the ceramic sleeve aligns with the LC/UPC female side before tightening; the step often missed is confirming the 1310 nm and 1550 nm wavelength match on both ends.

What maintenance or replacement will the adapter need later?

The zirconia ceramic sleeve is rated for over 1000 insertion cycles; plan to replace the adapter when insertion loss rises above .2 dB or return loss drops below 50 dB at 1310 nm.

What limit appears first during sustained use at high temperature?

The operating temperature range tops out at 95 °C; sustained operation near that limit will degrade the ceramic sleeve and increase insertion loss before the 1000-cycle mechanical rating is reached.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.