We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black SATA 15 pin male to Molex 4 pin LP4 female power adapter cable

Vszerda

Vszerda SATA to Molex Adapter 15Pin Male to 4Pin LP4 Female Power Cable

SKU CH-CNDY-Z3RSF

Adapts a SATA 15-pin power plug to a Molex 4-pin LP4 socket for 2.5 or 3.5 IDE drives

  • Connects legacy IDE drives to modern SATA power supplies
  • 15-pin SATA male plugs directly into ATX or EPS PSU
  • 4-pin LP4 female powers 2.5 and 3.5 hard disks
  • Supplies both 5 V and 12 V rails to the device
  • Simple plug-in installation requires no tools

Power adapter for legacy IDE drives

This SATA-to-Molex adapter lets you power older 2.5 or 3.5 inch IDE hard drives, optical drives and other LP4 devices from a modern ATX or EPS power supply. It bridges the gap when a PSU only offers SATA 15-pin connectors and your hardware still uses the large 4-pin interface. Installation is a simple plug-in with no tools required.

Passive connection runs without extra heat or noise

The adapter carries 5V and 12V DC directly from the PSU through a straight-through wiring layout. No active components, fans or circuitry are present, so it adds no audible noise, no measurable thermal load and negligible resistance to the power path. It behaves like a short extension of the existing cable loom.

Fits tight routing and frees a SATA header

The compact male SATA plug and female LP4 socket occupy minimal space behind drive cages or in narrow chassis channels. Using this adapter releases a native Molex lead on the PSU for other peripherals while consuming only one SATA power header. Cable length is short enough to avoid clutter but long enough for typical drive-bay placement.

Highlights

  • Connects legacy IDE drives to modern SATA power supplies
  • 15-pin SATA male plugs directly into ATX or EPS PSU
  • 4-pin LP4 female powers 2.5 and 3.5 hard disks
  • Supplies both 5 V and 12 V rails to the device
  • Simple plug-in installation requires no tools

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 15-pin SATA male connector to my power supply without bending the pins?

Align the keyed SATA 15-pin male connector with the PSU's SATA power port and press straight in until it clicks; forcing it at an angle is the common mistake that bends the delicate pins inside the housing.

Will the Molex 4-pin LP4 female connector or the SATA 15-pin male side wear out first with repeated drive swaps?

The Molex 4-pin LP4 female connector typically shows wear first because its larger pins and friction-fit design degrade faster than the SATA 15-pin male's tighter, keyed interface during frequent connections.

At what load does the 5V/12V DC rating become the limiting factor during sustained operation?

The 5V/12V DC rating limits total power delivery; sustained draws approaching the connector's current capacity cause voltage drop and heat buildup at the SATA 15-pin male and Molex 4-pin LP4 female junctions first.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.