We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black SATA power Y-splitter cables, 15-pin male to dual female, 7 inch length

Vszerda

Vszerda SATA Power Y Splitter Cable 15 Pin Male to Dual Female 7 Inch 2 Pack

SKU CH-RTGV-W0AEV

Turns one SATA power port into two 15-pin connectors for extra drives or optical units

Pack 2 packs

  • Turns one SATA power port into two for extra drives
  • 7 inch 18 AWG cable keeps builds tidy
  • 15 pin male to dual 15 pin female connectors
  • Powers 2.5 and 3.5 inch drives plus optical units
  • Supplies 3.3V 5V and 12V from single PSU connection

Practical Power Expansion

This SATA power Y splitter cable turns a single 15 pin connector from the power supply into two female ports. The 7 inch length suits tight chassis routing while supporting 2.5 inch SSDs, 3.5 inch hard drives and optical drives. Builders and upgraders gain extra device connections without replacing the PSU.

Wiring and Daily Use

Each splitter uses 18 AWG conductors rated for 3.3V, 5V and 12V rails from a standard ATX supply. The straight male plug and two female receptacles fit directly into existing cables, so no tools or adapters are required. Cable stiffness is moderate, allowing neat bundling behind the motherboard tray.

Current Limits and Planning

Total draw across both branches must stay within the source connector and PSU rail ratings. The 18 AWG gauge sets a practical ceiling lower than a dedicated PSU lead, so high spin up loads on multiple mechanical drives need checking. Verify the power supply label before adding several devices on one splitter.

Highlights

  • Turns one SATA power port into two for extra drives
  • 7 inch 18 AWG cable keeps builds tidy
  • 15 pin male to dual 15 pin female connectors
  • Powers 2.5 and 3.5 inch drives plus optical units
  • Supplies 3.3V 5V and 12V from single PSU connection

Specifications

No published specifications for this item yet.

Other versions of this model

1 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

Does the 15-pin SATA power splitter pass 3.3 V, 5 V and 12 V to both drives?

Yes, the cable carries 3.3 V, 5 V and 12 V from the PSU to each 15-pin female connector.

What clearance is needed for the 7-inch Y-cable inside a case?

The 7-inch (20 cm) length and 18 AWG wire allow routing behind motherboard trays or along drive cages in standard towers.

How do I connect the splitter without overloading the PSU rail?

Plug the single male end into the PSU SATA port, attach two drives to the female ends, then verify the PSU’s total 12 V current rating covers the added load.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.