We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green circuit board with a 15-pin SATA socket, a 40-pin IDE plug and a 4-pin Molex power connector

Vszerda

Vszerda SATA Female to 40 pin Male 3.5 inch IDE Adapter

SKU CH-9DPH-ZKNYA

Converts 3.5-inch IDE drives to SATA using a JM20330 chipset with 40-pin male and 7+15-pin female connectors plus Molex power

  • Connect SATA drives to legacy IDE systems via JM20330 chipset
  • Single adapter bridges 7+15 pin SATA female and 40-pin IDE male
  • 4-pin Molex input powers the converted drive directly
  • Driver-free installation works immediately on any compatible PC
  • Compact 3.5 inch form factor fits standard drive bays

Interface conversion

This Vszerda adapter bridges a SATA 7+15 pin female connector with a 40-pin male IDE connector and a 4-pin Molex power connection. It lets you attach a SATA SSD or hard drive to a legacy 3.5 inch IDE cable without installing any driver. The JM20330 chipset handles the translation between the two interfaces instantly.

Build and connectors

The unit presents a single female SATA port on one side and a male 40-pin PATA header plus Molex power on the other. Both ends are keyed to prevent misalignment during insertion. A compact circuit board keeps the assembly short so it fits inside tight drive bays without stressing the ribbon cable or the power lead.

Practical limits

Data moves at the speed of the slower bus, so a modern SATA drive will be limited by the IDE channel’s maximum throughput. The adapter draws operating power from the Molex connector; the host system must supply a free 4-pin lead. Hot-plug capability is not supported because the legacy IDE interface does not implement it.

Highlights

  • Connect SATA drives to legacy IDE systems via JM20330 chipset
  • Single adapter bridges 7+15 pin SATA female and 40-pin IDE male
  • 4-pin Molex input powers the converted drive directly
  • Driver-free installation works immediately on any compatible PC
  • Compact 3.5 inch form factor fits standard drive bays

Specifications

No published specifications for this item yet.

Questions about this item

What SATA standard does the JM20330 chipset support, and what throughput does that cap the adapter at?

The JM20330 bridges a SATA 7+15 pin female port to a 40 pin IDE male connector, so the link runs at SATA speeds; the IDE host side limits real-world throughput to the PATA bus maximum.

What physical clearance and connectors are required to fit this 3.5 inch adapter?

It needs a standard 3.5 inch drive bay or bracket, a free 40 pin IDE ribbon cable header, and a spare 4 pin Molex power plug for the adapter board itself.

How is the adapter installed, and which power step is often missed?

Connect the SATA drive to the 7+15 pin female port, plug the 40 pin male end into the IDE cable, then attach a 4 pin Molex power connector to the adapter — forgetting that Molex link is the common mistake.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.