Vszerda
Vszerda SATA 15-pin male to 2×15-pin female Y-splitter 22 cm
Splits one SATA 15-pin power connector into two for 2.5" and 3.5" drives with 22 cm 18AWG cable
- Typecomputer-usb-cables
- Color22cm
- Length22
- Connector DetailUsb
- Terminal GenderMale-to-Female
- Featurescalculator
- Adds two SATA power ports from one 15-pin male connector
- Supplies 3.3 V on all five wires for stable drive power
- 22 cm length fits tight 2.5" SSD or 3.5" HDD bays
- 18 AWG tinned copper conductors rated for reliable current delivery
- Works with SSD, HDD, optical and Blu-ray drives with SATA power ports
Power-splitter purpose
This SATA power Y-splitter turns one 15-pin male connector into two 15-pin female connectors so a single PSU lead can feed two drives. It is built for 2.5-inch SSDs, 3.5-inch HDDs and optical drives that use standard SATA power ports. The cable is not intended for any other interface and the supplier warns that mis-connection can damage components.
Capacity and headroom
The 22 cm length suits tight drive cages or short runs between stacked bays, while the 32 cm option gives extra reach for full-tower layouts. Each branch carries the full 5-wire set including the 3.3 V line, so drives that require 3.3 V power will start correctly. The 18 AWG conductors and 2.1 mm outer diameter limit voltage drop on typical consumer drives, but very long daisy-chains or high-spin-up-current arrays may exceed the wire’s comfort zone.
15-pin SATA power interface
The single deciding specification is the 15-pin SATA power connector with all five voltage lines present, including 3.3 V. If your drive or backplane expects that complete pinout the splitter will work; if the device uses a different power interface or omits the 3.3 V line you need a different adapter.
Highlights
- Adds two SATA power ports from one 15-pin male connector
- Supplies 3.3 V on all five wires for stable drive power
- 22 cm length fits tight 2.5" SSD or 3.5" HDD bays
- 18 AWG tinned copper conductors rated for reliable current delivery
- Works with SSD, HDD, optical and Blu-ray drives with SATA power ports
Specifications
| Brand | XAGMODSHN |
|---|---|
| Model | 7666540383329 |
| Type | computer-usb-cables |
| Color | 22cm |
| Length | 22 |
| Connector Detail | Usb |
| Terminal Gender | Male-to-Female |
| Features | calculator |
Questions about this item
Will the 22 cm Y-splitter reach both drives when I keep my existing 3.5" HDD and add a 2.5" SSD?
The 22 cm cable provides two 15-pin female connectors from one male plug, so you can power a 3.5" HDD and a 2.5" SSD simultaneously if the drives are mounted close together.
How can I verify the splitter delivers the 3.3 V line correctly after installation?
Measure the yellow, red and orange wires at each female connector with a multimeter; you should see 12 V, 5 V and 3.3 V respectively on the 5-digit pinout.
Does the package include any mounting hardware or extra cables for the second drive?
The box contains only the 18 AWG Y-splitter cable itself; no screws, brackets or additional power leads are supplied.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



