We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black flat ribbon cable with white 36-pin PCIe x1 connectors at right angles and small LED module

Vszerda

Vszerda PCIe x1 Riser Cable 36Pin 3.3V 12V LED 90° Vertical 3.0

SKU CH-MT63-70JGN

A PCIe 3.0 x1 riser cable with 36-pin connectors, 3.3 V and 12 V power LEDs, and dual 90-degree vertical orientation extends the slot by 12 cm

  • PCIe 3.0 x1 extension supports 36-pin connectivity
  • Dual 3.3V and 12V LEDs indicate power status
  • 90° vertical orientation fits tight chassis spaces
  • 12-inch cable length enables flexible GPU placement

PCIe 3.0 x1 riser cable with power LEDs

This Vszerda riser cable extends a PCI Express 3.0 x1 slot using a 36-pin connector. It carries both 3.3 V and 12 V power lines and includes dual LEDs that show when each rail is live. The vertical 90-degree bracket lets the connected card sit upright in tight chassis layouts.

Suits builders adding a single x1 card

Not suited for slots wider than x1 or for installations that need a horizontal card orientation. Buyers who require longer reach or a different bracket angle should look at other extension options.

Highlights

  • PCIe 3.0 x1 extension supports 36-pin connectivity
  • Dual 3.3V and 12V LEDs indicate power status
  • 90° vertical orientation fits tight chassis spaces
  • 12-inch cable length enables flexible GPU placement

Specifications

No published specifications for this item yet.

Questions about this item

What clearance does the 90° vertical connector need above the motherboard slot?

The 90° vertical connector stands upright from the PCIe x1 slot, so allow enough height above the board for the cable to bend without pressing against other components or the case side panel.

Which step do builders often miss when seating the 36-pin connector?

Push the 36-pin plug fully into the motherboard PCIe x1 slot until the retention clip clicks; a partial seat leaves the 3.3 V and 12 V power LEDs unlit and the link inactive.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.