Vszerda
Vszerda PCIe 4.0 x16 to 4 M.2 NVMe Adapter with Heat Sink
Adds four M.2 NVMe slots via a PCIe 4.0 x16 link with a combined 256 Gbps bandwidth and a heat sink
- Connect four NVMe SSDs via one PCIe 4.0 x16 slot
- Theoretical 256 Gbps total bandwidth for high-throughput workloads
- Supports M.2 2230, 2242, 2260 and 2280 form factors
- Works with PCIe 1.0 through 4.0 standards
- Boot from NVMe with BIOS PCIe boot support
Four-slot NVMe expansion card
The Vszerda PCIe 4.0 x16 adapter connects four M.2 NVMe SSDs at once. It fits drives in 2230, 2242, 2260 and 2280 lengths. A large aluminium heat sink covers all four slots to keep temperatures down under sustained loads. The card is aimed at workstation users and enthusiasts who need more high-speed storage than their motherboard provides.
Adds four NVMe slots over a single x16 slot
The adapter turns one PCIe 4.0 x16 connection into four M.2 ports with a combined theoretical bandwidth of 256 Gbps. It also works in PCIe 1.0 slots, though speed scales with the link width. The upgrade is worth it when the board has no free M.2 sockets or when a project demands several terabytes of fast scratch space without adding another controller card.
Suits builders with a spare x16 slot
Systems that can boot from PCIe NVMe drives will start quickly from any drive on this card. Builders whose motherboard lacks PCIe bifurcation or whose chassis cannot fit a full-height card should look elsewhere. Anyone needing RAID features not provided by the host platform will need a dedicated RAID controller instead.
Highlights
- Connect four NVMe SSDs via one PCIe 4.0 x16 slot
- Theoretical 256 Gbps total bandwidth for high-throughput workloads
- Supports M.2 2230, 2242, 2260 and 2280 form factors
- Works with PCIe 1.0 through 4.0 standards
- Boot from NVMe with BIOS PCIe boot support
Specifications
No published specifications for this item yet.
Questions about this item
What PCIe slot size does this Vszerda adapter need to fit?
The card uses a PCIe 4.0 x16 edge connector, so it requires a full-length x16 slot on the motherboard.
How are the four NVMe drives secured during installation, and what step is often missed?
Each M.2 drive is held by a screw on the PCB; the step often missed is fitting the supplied standoff for the 2230, 2242, 2260 or 2280 length before tightening the screw.
When should the thermal pads on the heat sink be replaced?
Replace the pads if they become compressed, dried out or no longer make full contact with the NVMe controllers after a drive swap.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



