Vszerda
Vszerda N38489 SATA 90° Male-to-Female Adapter 6 pcs
Six right-angled SATA 7-pin male-to-female adapters redirect cables 90 degrees for tight chassis clearance
- Color6 PCS
- Terminal GenderMale-to-Female
- ConductorPlastic
- Changes cable direction by 90 degrees for tight spaces
- Male-to-female design keeps existing SATA cables compatible
- Compact 1.3 by 1.2 cm body fits low-profile chassis
- Six adapters included for multiple drive installations
- Metal and plastic construction ensures durable connections
Right-Angle SATA Cable Adapter
This Vszerda N38489 adapter changes the direction of a SATA 7-pin data cable by ninety degrees. The male-to-female design lets you route the cable from vertical to horizontal inside the chassis. A pack of six units is included for multiple drives or builds.
Builders with Tight Clearances
The right-angle connector solves fitting issues in low-profile cases where a straight cable would press against the side panel or other components. Installers who need a straight-through connection or a different angle should look elsewhere.
90-Degree Male-to-Female Orientation
The single specification that decides fit is the ninety-degree angle between the male header and the female receptacle. Verify that this orientation matches the space between your motherboard port and the drive bay.
Highlights
- Changes cable direction by 90 degrees for tight spaces
- Male-to-female design keeps existing SATA cables compatible
- Compact 1.3 by 1.2 cm body fits low-profile chassis
- Six adapters included for multiple drive installations
- Metal and plastic construction ensures durable connections
Specifications
| Brand | Vszerda |
|---|---|
| Model | N38489 |
| Color | 6 PCS |
| Terminal Gender | Male-to-Female |
| Conductor | Plastic |
Questions about this item
Does the SATA 90° adapter support the full SATA interface speed?
The adapter is a passive 7-pin male-to-female connector and does not limit the SATA interface speed; the link runs at whatever rate the host controller and drive negotiate.
How much clearance does the 1.3 cm by 1.2 cm body need beside the motherboard port?
The right-angle body measures roughly 1.3 cm wide by 1.2 cm deep, so allow at least that much space next to the SATA port for the cable to run horizontally.
How do I install the six adapters without bending the cable the wrong way?
Plug each male end into the motherboard or drive SATA port, then attach the existing cable to the female side so the cable exits horizontally; the common mistake is forcing the cable upward instead of letting the 90° bend route it flat.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



