We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black braided IDE power splitter cable with one large 4-pin male plug and two large 4-pin female sockets, 20cm long

Vszerda

Vszerda IDE 4-pin male to dual female power extension cable 20cm

SKU CH-1GW4-JBRYV

Splits one IDE 4-pin power connector into two with 20 cm braided copper cable

  • ColorBlack
  • ConductorCopper
  • FeaturesBraided
  • Splits one IDE power connector into two drives
  • 18 AWG UL-certified copper wire meets safety standards
  • 20 cm braided length keeps cable routing tidy
  • Black eco-friendly shells protect pins from damage
  • Brass-tinned contacts ensure reliable power delivery

Vszerda IDE 4-Pin Power Splitter

This Vszerda cable splits a single large IDE 4-pin male connector into two female connectors. It extends power from a PSU to two legacy drives or devices using 18AWG copper conductors with brass tinned terminals. The 20cm length suits compact builds or tight drive bays. A black braided sleeve protects the wires and resists abrasion.

Suits legacy drive upgrades; not for SATA power

Builders adding a second IDE hard drive or optical drive to an existing Molex lead will find this splitter practical. The dual female ends allow daisy-chaining without a second PSU cable. Systems that only provide SATA power connectors cannot use this adapter directly. Buyers needing SATA power outputs should select a different cable type.

Single 20cm length with 18AWG conductors

The fixed 20cm reach determines whether the splitter spans the gap between your PSU cable and both drive sockets. The 18AWG copper wire gauge sets the safe current capacity for the connected devices. Verify that this length and gauge match your chassis layout and power requirements before ordering.

Highlights

  • Splits one IDE power connector into two drives
  • 18 AWG UL-certified copper wire meets safety standards
  • 20 cm braided length keeps cable routing tidy
  • Black eco-friendly shells protect pins from damage
  • Brass-tinned contacts ensure reliable power delivery

Specifications

BrandVszerda
ColorBlack
ConductorCopper
FeaturesBraided

Questions about this item

Does the 18 AWG wire on this Vszerda IDE power splitter run warm when both connected drives spin all day?

The 18 AWG copper conductors are rated for typical IDE drive currents, so heat stays low even with two devices drawing power continuously.

What power connector must my supply already have to plug this 20 cm extension in?

Your power supply needs a free large 4-pin Molex (IDE) male connector to accept the cable's male plug.

Will this splitter work with the older 3.5-inch IDE hard drives I still use?

Yes, both female ends are standard large 4-pin IDE sockets, matching the power ports on legacy 3.5-inch IDE drives.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.