Vszerda
Vszerda Down Angled SATA III 3.0 7+15 22 Pin Male to Female Extension Cable 30cm
A 22-pin SATA 3.0 extension cable combining 15-pin power and 7-pin data with a down-angled connector, 30cm long
- Color22Pin Cable
- SpecificationsCopper, 22Pin Cable, SATA 3.0 Disk, 1
- ConductorCopper
- ConstructionCopper
- Down-angled connector fits tight drive bays
- 22-pin design carries both data and power in one cable
- 30 cm length gives flexible routing inside the case
- Copper conductors support SATA 3.0 transfer speeds
- 15-pin power plus 7-pin data connectors match standard drives
Down-Angled SATA Extension
This 22-pin cable combines a 15-pin power segment with a 7-pin data segment in a single male-to-female assembly. It carries SATA 3.0 signals and delivers both 5 V and 12 V lines through four copper conductors. The down-angled connector eases routing in tight drive bays or behind backplanes.
Build and Daily Use
Copper conductors provide reliable conductivity for power and data across the 30 cm length. The integrated 22-pin layout reduces cable clutter by merging power and data into one run. The angled hood points the cable downward, helping it clear adjacent components without sharp bends.
30 cm Reach Constraint
At 30 cm the extension suits short hops such as drive-to-backplane or drive-to-controller links inside the same chassis. Builds that need longer runs across full-tower cases or to external enclosures will find the length insufficient.
Highlights
- Down-angled connector fits tight drive bays
- 22-pin design carries both data and power in one cable
- 30 cm length gives flexible routing inside the case
- Copper conductors support SATA 3.0 transfer speeds
- 15-pin power plus 7-pin data connectors match standard drives
Specifications
| Brand | xiwai |
|---|---|
| Color | 22Pin Cable |
| Specifications | Copper, 22Pin Cable, SATA 3.0 Disk, 1 |
| Conductor | Copper |
| Construction | Copper |
Questions about this item
What SATA standard does this 22-pin cable support and what speed does it cap at?
It is built to the SATA III 3.0 specification, so data transfers run at up to 6 Gb/s.
What clearance does the down-angled 22-pin connector need to fit?
The right-angle hood points downward, so allow roughly 15 mm of vertical space behind the drive for the plug to seat without stress.
How do I install the 7+15 pin extension without bending the power pins?
Align the L-shaped key on both the 7-pin data and 15-pin power ends, push straight in until the metal shell clicks, and avoid rocking the connector sideways.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



