We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Double SATA 7-pin angled adapter cable with 90 and 180 degree connectors

Vszerda

Vszerda Double SATA 7Pin Female to 7Pin Male 90 180 Angled internal power cable

SKU CH-1SMK-5QGA8

Angled SATA 7-pin connectors at 90 and 180 degrees adapt motherboard ports for tight internal routing

  • 90 or 180 degree connectors fit tight spaces
  • Double SATA female to male adapters extend drive links
  • Angled elbows reduce cable strain on motherboard headers
  • Turning design allows flexible routing inside case

Double SATA angled adapter

This adapter provides two SATA 7-pin female connectors that plug into a single SATA 7-pin male header, each with a 90 or 180 degree elbow. It is designed for builders who need to route data cables around tight motherboard layouts or crowded drive cages. The low-profile elbows reduce strain on the port and keep the cable path tidy inside compact cases.

Limited to SATA data only

The connector carries the SATA data signal and does not supply power to attached drives. Builders who want to power drives from the same header cannot do so with this adapter. The fixed 90 and 180 degree angles suit many layouts but cannot be adjusted to other orientations.

Highlights

  • 90 or 180 degree connectors fit tight spaces
  • Double SATA female to male adapters extend drive links
  • Angled elbows reduce cable strain on motherboard headers
  • Turning design allows flexible routing inside case

Specifications

No published specifications for this item yet.

Questions about this item

Should I pick the 90-degree or 180-degree angled connector for my motherboard layout?

Choose the 90-degree angle when the SATA port sits close to a side panel or large component; choose the 180-degree angle when the cable needs to run parallel to the board surface.

What does the 7-pin SATA interface actually carry once installed?

The 7-pin SATA connector carries only the data signal; a separate 15-pin power lead from your PSU is still required for the drive to operate.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.