Vszerda
Vszerda DisplayPort 2.1 cable 3.3ft 40Gbps 8K60Hz 4K144Hz 2K240Hz
A 3.3 ft DisplayPort 2.1 cable delivering 40 Gbps for 8K at 60 Hz, 4K at 144 Hz and 2K at 240 Hz with triple shielding and 28 AWG conductors
- Supports 8K at 60 Hz with DSC for ultra-high resolution
- Delivers 4K at 144 Hz and 2K at 240 Hz for smooth gaming
- 40 Gbps bandwidth enables high-refresh multi-monitor setups
- Backwards compatible with DisplayPort 1.4 and 1.2 devices
- Triple-shielded 28 AWG OFC conductor reduces signal interference
DisplayPort 2.1 cable for 8K60Hz gaming
This Vszerda cable carries DisplayPort 2.1 signals at 40Gbps over a 3.3ft run. It supports 8K at 60Hz with DSC, 4K at 144Hz or 120Hz, 2K at 240Hz, and 1080P at 360Hz. The link is HDCP compliant and works with FreeSync and G-Sync variable-refresh displays. It suits gamers and creators who need high refresh rates at high resolutions.
Upgrade from DP 1.4 or 1.2 cables
The cable is backwards compatible with DisplayPort 1.4 and 1.2 equipment, so it drops into existing ports without adapters. The jump is worth it when your monitor and graphics card both support DP 2.1 UHBR10 and you want 4K above 120Hz or 2K above 144Hz. Older cables cannot deliver the 40Gbps bandwidth those modes require.
Handles 8K60Hz single or multi-monitor 4K60Hz
A single 8K60Hz stream fits within the 40Gbps link using DSC 1.2a compression. The same bandwidth can drive two 4K60Hz screens or three 2K60Hz screens simultaneously. It runs out when you need uncompressed 8K above 60Hz or 4K above 144Hz without DSC, which would exceed the UHBR10 limit.
Highlights
- Supports 8K at 60 Hz with DSC for ultra-high resolution
- Delivers 4K at 144 Hz and 2K at 240 Hz for smooth gaming
- 40 Gbps bandwidth enables high-refresh multi-monitor setups
- Backwards compatible with DisplayPort 1.4 and 1.2 devices
- Triple-shielded 28 AWG OFC conductor reduces signal interference
Specifications
No published specifications for this item yet.
Questions about this item
Will the 3.3ft cable reach my monitor if the PC is on the floor?
The cable is 3.3ft long, so measure from your graphics card port to the monitor input; allow a little slack for routing behind the desk.
Do I need to install any driver or firmware for the 80Gbps DisplayPort 2.1 link to work?
No driver is required; the cable is passive and backwards compatible with DP 1.4 and 1.2, so the link negotiates automatically once both ends are seated firmly.
How often should I replace the 28AWG OFC conductors to keep 8K60Hz performance?
The conductors are solid copper and do not degrade under normal use; replace only if the cable is kinked, the latch breaks, or you see intermittent signal loss.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



