Vszerda
Vszerda ARGB Fan Hub 10-Port 5V-3Pin Magnetic SATA White
Controls up to 10 ARGB fans with magnetic mounting, RF remote, SATA power and PWM speed monitoring in a compact 3.83 x 2.33 x .6 inch white hub
- Handles 10 ARGB fans with magnetic mounting for tidy wiring
- RF remote and chassis key give instant lighting control
- SATA power input delivers stable current to all connected fans
- Compact 3.83 x 2.33 x .6 inch design keeps case interior neat
- PWM speed monitoring on the red port enables temperature-based fan control
10-Port ARGB Hub for PWM Fans
The Vszerda ARGB Fan Hub connects up to 10 addressable RGB fans or 5V 3-pin LED strips through a single controller. Magnetic suction mounting keeps the unit secure inside the case without screws. A SATA power cable draws electricity directly from the power supply, avoiding voltage drop on the motherboard header. An RF remote and the chassis reset button both change lighting modes without software.
Upgrade From Single-Header ARGB Control
Most motherboards provide only one 5V 3-pin header, limiting builders to a few daisy-chained devices. This hub replaces that bottleneck by splitting the signal across ten ports while preserving PWM speed monitoring on the designated red port. The jump is worth it when a build uses more than two ARGB fans or adds light strips, and the motherboard header cannot supply enough current for stable operation.
Suits Builders With Many ARGB Devices
The hub suits enthusiasts assembling white-themed systems who need tidy cable routing and centralised lighting control for ten 5V ARGB components. It does not support 12V 4-pin RGB hardware, so buyers with older four-pin strips or fans should look elsewhere. Users who require motherboard-software synchronisation across multiple independent zones will also need a different solution.
Highlights
- Handles 10 ARGB fans with magnetic mounting for tidy wiring
- RF remote and chassis key give instant lighting control
- SATA power input delivers stable current to all connected fans
- Compact 3.83 x 2.33 x .6 inch design keeps case interior neat
- PWM speed monitoring on the red port enables temperature-based fan control
Specifications
No published specifications for this item yet.
Questions about this item
What case clearance does the 3.83 x 2.33 x .6 inch hub need for magnetic mounting?
The hub measures 3.83 by 2.33 by .6 inches, so any flat steel surface with at least that footprint will hold it magnetically.
Which port must connect to the motherboard for PWM speed control to work?
Plug the PWM cable into the red port; only the fan on that port reports speed back to the motherboard.
How many ARGB devices can be powered before a second SATA connection is required?
The single SATA power input supports all ten 5 V 3-pin ARGB ports simultaneously.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
