We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 6-pin male connector splitting to three IDE female connectors on flat ribbon cable

Vszerda

Vszerda 6Pin Male to 3 IDE Female Power Splitter Cable 40CM+15CM+15CM 18AWG

SKU CH-JJZM-TM7JR

Connects a modular 6-pin PSU output to three IDE devices using 18 AWG tinned-copper wire with 40 cm, 15 cm and 15 cm branches

  • Splits one modular 6-pin connector into three IDE power ports
  • 18 AWG tinned-copper conductors carry 5 V and 12 V reliably
  • 40 cm lead plus two 15 cm branches reach drives across the case
  • 1-to-3 port multiplier adds Molex devices without extra PSU cables
  • Designed for Seasonic KM3 series modular power supplies

Vszerda 6Pin to 3 IDE Power Splitter

This 18AWG tinned-copper cable splits one 6Pin male connector into three IDE female ports. It is built for Seasonic KM3 Series modular power supplies. The 1:3 multiplier lets builders add multiple legacy drives or accessories from a single modular output. Ideal for system integrators updating older storage configurations.

Practical limits of the 6Pin modular interface

The cable delivers 5V and 12V rails through a total run of 40CM to the first branch and 15CM to each of the two additional connectors. Current capacity is constrained by the 18AWG wire gauge and the source modular port rating. Voltage drop increases with load across all three branches, so high-draw devices should be evaluated individually.

Check your modular PSU

Verify that your power supply uses the Seasonic KM3 Series 6Pin pin-out; other modular standards are not compatible. Confirm each target drive or accessory uses a standard 4Pin IDE power socket. Ensure the 40CM primary length and 15CM branch lengths reach your drive bays without strain.

Highlights

  • Splits one modular 6-pin connector into three IDE power ports
  • 18 AWG tinned-copper conductors carry 5 V and 12 V reliably
  • 40 cm lead plus two 15 cm branches reach drives across the case
  • 1-to-3 port multiplier adds Molex devices without extra PSU cables
  • Designed for Seasonic KM3 series modular power supplies

Specifications

No published specifications for this item yet.

Questions about this item

How do the three IDE connectors share the 40 cm and 15 cm leads?

The splitter provides one 40 cm lead to the first IDE connector and two 15 cm leads to the remaining connectors, all from a single 6-pin male plug.

What power can the 18 AWG tinned copper wires deliver to IDE drives?

18 AWG tinned copper carries the 5 V and 12 V lines needed for standard IDE hard drives and optical drives.

What does the 6-pin male to IDE female interface connect in a Seasonic KM3 modular supply?

The 6-pin male plugs into the modular port on a Seasonic KM3 supply and splits into three IDE female connectors for legacy drives.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.