We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Six black flat cables with EPS 8-pin to dual PCIe 8-pin connectors

Vszerda

Vszerda 6-Pack EPS 8 Pin to Dual PCIe 8 Pin (6+2) Cable for Corsair PSU

SKU CH-WPJT-7PT9T

Six cables connect a Corsair modular PSU EPS port to two graphics-card power sockets each using 18 AWG wire at 12 volts

  • Length10 feet
  • Connector DetailMale-to-Male
  • SpecificationsVoltage: 12 volts; Connector: Male-to-Male
  • Six cables power multiple GPUs from one PSU
  • EPS 8-pin connects to Corsair modular PSUs only
  • Each cable splits into two PCIe 8-pin (6+2) connectors
  • 18AWG wire handles heavy-duty 12 V loads
  • 10 ft flat black cables improve airflow and cable routing

Six-Pack EPS-to-Dual-PCIe Cable Set

This six-pack converts a single EPS 8-pin output on a Corsair modular power supply into two PCIe 8-pin (6+2) connectors. It targets builders who run multiple graphics cards or a single card that requires dual 8-pin power from one PSU port. The cables are wired male-to-male and rated for 12-volt delivery.

18AWG Wire Handles Continuous Load

Thick 18AWG conductors are specified for heavy-duty use, meaning the cables maintain stable voltage under sustained GPU load rather than only during brief peaks. The flat-array layout reduces internal resistance and helps airflow stay unobstructed during long rendering or gaming sessions.

Flat Black Design Simplifies Routing

Each cable measures approximately 25 inches, giving enough reach for full-tower or mid-tower routing without excess slack. The fully black, flexible flat profile tucks cleanly behind motherboard trays and along PSU shrouds. Compatibility is limited to listed Corsair RM, RMX, RMi, HX, HXi, AX, AXi, SF, TX, TX-M, CS, CS-M, CX and CX-M series; the AX1200 is explicitly excluded.

Highlights

  • Six cables power multiple GPUs from one PSU
  • EPS 8-pin connects to Corsair modular PSUs only
  • Each cable splits into two PCIe 8-pin (6+2) connectors
  • 18AWG wire handles heavy-duty 12 V loads
  • 10 ft flat black cables improve airflow and cable routing

Specifications

BrandJZYMOD
Length10 feet
Connector DetailMale-to-Male
SpecificationsVoltage: 12 volts; Connector: Male-to-Male

Questions about this item

Does the 18AWG wire gauge and flat array design keep heat and noise low when the cables run at 12 volts all day?

The 18AWG conductors and flat layout promote airflow, helping the cables stay cool and quiet during continuous 12-volt operation.

Which Corsair modular PSU series must I already own for these EPS-to-dual-PCIe cables to plug in correctly?

They fit RM, RMX, RMi, HX, HXi, AX, AXi, SF, TX, TX-M, CS, CS-M, CX and CX-M series; AX1200 is not supported.

Will the 6+2 pin ends power an older graphics card that only has a 6-pin socket?

Yes, each 6+2 connector splits to supply either an 8-pin or a 6-pin GPU socket, so legacy cards work without adapters.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.