We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular 5.25 inch front panel with touchscreen LCD display and fan control buttons

Vszerda

Vszerda 5.25" Touchscreen LCD 5-Way Fan Speed Controller Front Panel

SKU CH-D5CE-HECB2

A 5.25-inch front-panel controller manages five fans with touchscreen temperature monitoring, RPM display and fail alarm

  • Controls five fans independently up to 10 W each for precise cooling balance
  • Automatic temperature monitoring adjusts fan speeds to prevent overheating
  • Manual touchscreen control lets you set exact RPM per channel
  • Audible fan-fail alarm warns before components overheat
  • Fits standard 5.25" bay with 60 cm Molex-powered cables

5.25" Touchscreen Fan Controller for PC Builders

This Vszerda unit fits a standard 5.25-inch drive bay and manages up to five 3-pin or 4-pin fans through a resistive touchscreen LCD. It suits enthusiasts who want direct, at-a-glance control over cooling without relying on software utilities or motherboard headers. Buyers who need more than five channels or software-based fan curves should look elsewhere.

Sustained Load Behaviour

Each channel delivers up to 10 watts for a combined 50-watt budget, with output voltage adjustable between 5 and 12 volts. In automatic mode the controller reads the included temperature probes and ramps fans to an effective speed when heat rises; manual mode lets you set each channel independently. An audible alarm sounds if a fan fails or the temperature exceeds your preset threshold.

Installation in a 5.25-Inch Bay with Molex Power

The controller measures 15 by 7.7 by 4.3 centimetres and mounts in a single front-panel bay using the supplied 60-centimetre cables. Power comes from a standard Molex 4-pin connector, so no extra adapters are required. Builders with cases that lack external 5.25-inch bays cannot install this unit.

Highlights

  • Controls five fans independently up to 10 W each for precise cooling balance
  • Automatic temperature monitoring adjusts fan speeds to prevent overheating
  • Manual touchscreen control lets you set exact RPM per channel
  • Audible fan-fail alarm warns before components overheat
  • Fits standard 5.25" bay with 60 cm Molex-powered cables

Specifications

No published specifications for this item yet.

Questions about this item

How much heat does the controller itself add when it runs all day at the full 50 W output?

The unit draws power from a Molex 4-pin connector and delivers up to 50 W total across five channels, so its own dissipation stays well within that envelope.

What power and fan connectors must already be present in the case for this panel to work?

You need one free Molex 4-pin lead from the PSU and up to five 3-pin or 4-pin fan headers to plug into the controller's 60 cm cables.

Will the voltage range of 5 V to 12 V safely drive older 3-pin fans that only spec 12 V?

Yes, each channel adjusts output between 5 V and 12 V, so legacy 3-pin fans receive their rated voltage at maximum and reduced voltage when slowed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.