We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black sleeved cable splitting one 4-pin IDE connector into five SATA power plugs, 40cm long

Vszerda

Vszerda 4-Pin IDE to 5 SATA Power Cable Splitter 18AWG Black Sleeved 40cm

SKU CH-3TTG-V604N

Connects one 4-pin IDE supply to five SATA drives using 18 AWG sleeved wiring over 40 cm

  • Converts one IDE connector into five SATA power ports
  • 18AWG conductors handle high-current drives reliably
  • Black sleeving protects wires and simplifies cable routing
  • 40cm length fits standard chassis layouts

Vszerda 4-Pin IDE to 5 SATA Power Splitter

This adapter converts a single 4-pin IDE connector into five SATA power outputs for internal drives. It suits builders adding multiple hard disks or SSDs to a system with limited Molex headers. The 18AWG conductors handle typical drive currents and the black sleeving keeps the loom tidy inside a server or workstation chassis. Length is 40cm from the IDE plug to the first SATA connector.

Installation notes and common issues

Plug the IDE end into a free Molex lead from the power supply and press each SATA head onto a drive until it clicks. The 40cm reach fits most mid-tower layouts but can fall short in full-tower cases where drives sit far from the PSU. Total current is shared across all five outputs so loading every port with high-spin-up drives may trip the rail; stagger spin-up in BIOS if the board allows it. The splitter adds no voltage regulation — it simply passes the rail through.

Highlights

  • Converts one IDE connector into five SATA power ports
  • 18AWG conductors handle high-current drives reliably
  • Black sleeving protects wires and simplifies cable routing
  • 40cm length fits standard chassis layouts

Specifications

No published specifications for this item yet.

Questions about this item

How can I confirm the splitter is delivering power to all five SATA drives after installation?

Verify each connected drive spins up and appears in the system BIOS or operating system disk utility.

What connectors are included on the cable and do I need any extra adapters?

The cable has one 4-pin IDE male plug and five SATA power connectors; no additional adapters are required for standard drives.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.