Vszerda
Vszerda 4.8 x 1.7mm Male to 5.5 x 2.1mm Female Power Adapter Cord 10cm
Connects a 4.8 x 1.7 mm power plug to a 5.5 x 2.1 mm jack in a 10 cm cord
- Connects 4.8 x 1.7mm power sources to 5.5 x 2.1mm devices
- Compact 10cm length keeps cable runs tidy
- Lightweight build makes it easy to transport
- High-quality construction ensures reliable power delivery
- Direct male-to-female fit simplifies laptop charging setups
Connector Conversion for Laptop Power
This adapter converts a 4.8 x 1.7mm male barrel plug to a 5.5 x 2.1mm female jack. It allows a charger with the smaller tip to power a laptop requiring the larger barrel size. The cord measures 10cm end to end. It is built for portable use between compatible devices.
Stable Contact Under Continuous Draw
The short cable run keeps resistance low during sustained charging sessions. Solid brass contacts maintain a firm grip inside both barrel sizes without loosening from vibration. The moulded strain relief protects the solder joints where the wire meets each connector. No active components mean nothing to overheat or throttle over time.
Barrel Jack Polarity and Size Limits
The adapter passes centre-positive polarity straight through without alteration. It only bridges the two stated diameters — 4.8mm to 5.5mm outer and 1.7mm to 2.1mm inner. Devices using centre-negative wiring, locking collars, or non-standard pin depths will not mate correctly. Voltage and current remain governed by the source charger and laptop requirements.
Highlights
- Connects 4.8 x 1.7mm power sources to 5.5 x 2.1mm devices
- Compact 10cm length keeps cable runs tidy
- Lightweight build makes it easy to transport
- High-quality construction ensures reliable power delivery
- Direct male-to-female fit simplifies laptop charging setups
Specifications
No published specifications for this item yet.
Questions about this item
Does the 10 cm cord add noticeable heat or power loss during all-day use?
The short 10 cm length keeps resistance minimal, so the adapter does not generate measurable heat or power loss during continuous operation.
What must my laptop and power supply already have for this 4.8 x 1.7 mm male to 5.5 x 2.1 mm female adapter to work?
Your laptop needs a 4.8 x 1.7 mm DC input jack and your power supply must terminate in a 5.5 x 2.1 mm male plug for the adapter to connect both sides.
Will this adapter fit older chargers that use the same 5.5 x 2.1 mm tip?
Yes, any legacy charger with a 5.5 x 2.1 mm male connector will mate with the female side, letting you power a 4.8 x 1.7 mm laptop port.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



