We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A short black Y cable with a 20 pin motherboard header on one end and two USB 3.0 Type A female ports on the other

Vszerda

Vszerda 2-Port USB 3.0 Female to 20-Pin Header Cable 30cm

SKU CH-0EPZ-E6N75

Adds two USB 3.0 Type-A ports to a motherboard 20-pin header with a 30 cm Y-cable

  • Adds two front-panel USB 3.0 ports via 20-pin header
  • 30 cm cable reaches most front-panel cut-outs
  • Y-splitter uses 19 of 20 header pins
  • Backwards compatible with USB 2.0 devices
  • Plug-and-play install into standard PCI bracket slot

Front-panel USB 3.0 expansion

This cable converts a single motherboard 20-pin header into two external USB 3.0 Type-A ports for the front panel. It is designed for DIY builders who need additional high-speed connections on their chassis. The 30 cm length suits standard tower layouts and plugs directly into compatible headers. No PCI bracket is included with the adapter.

Two ports from one 20-pin header

The Y-splitter provides 19 active pins across the 20-hole connector, leaving one hole unused as noted by the supplier. It supports USB 3.0 SuperSpeed operation and remains backwards compatible with USB 2.0 devices such as card readers, external drives or hubs. Bandwidth is shared between the two ports, so simultaneous heavy transfers will reduce per-port throughput. The short cable limits placement to front-panel cut-outs near the motherboard header.

20-pin header compatibility check

This adapter requires a motherboard USB 3.0 20-pin header; it will not work with older 19-pin USB 2.0 headers or internal USB-C connectors. Builders must verify their board exposes the correct keyed header before purchase. The cable is not suitable for systems lacking a front-panel USB 3.0 header or for external rear-I/O expansion.

Highlights

  • Adds two front-panel USB 3.0 ports via 20-pin header
  • 30 cm cable reaches most front-panel cut-outs
  • Y-splitter uses 19 of 20 header pins
  • Backwards compatible with USB 2.0 devices
  • Plug-and-play install into standard PCI bracket slot

Specifications

No published specifications for this item yet.

Questions about this item

Will this 20-pin header cable work with my older motherboard that only has a 19-pin USB 3.0 connector?

The Y-shaped cable has 19 pins while the connector provides 20 holes, leaving one hole unused, so it fits both 19-pin and 20-pin motherboard headers.

How can I verify the two Type-A ports are running at USB 3.0 speed after I plug the cable into my motherboard header?

Connect a USB 3.0 device and check that the operating system reports a SuperSpeed connection; the ports are backwards compatible with USB 2.0, so a 2.0 device will still work but at the lower rate.

Does the package include the PCI bracket shown in some product photos, or do I need to buy a bracket separately?

The manufacturer notes state the PCI bracket is excluded, so only the 30 cm dual-port cable is supplied; a bracket must be sourced separately if your case requires one.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.