Vszerda
Vszerda 1-to-10 4-Pin PWM Fan Hub Splitter Cable SATA Black
SATA-powered hub splits one PWM header into ten 12 V 4-pin fan connectors with automatic speed control and adhesive mounting
- Connect up to ten 12 V PWM fans from one motherboard header
- PWM signal passes through for automatic speed control on all connected fans
- Dedicated orange CPU-fan header ensures correct RPM reporting to the motherboard
- SATA power connector supplies reliable 12 V current for all ten channels
- Compact 7.5 cm hub with adhesive backing fits neatly inside any case
Fan hub for up to 10 PWM fans
The Vszerda splitter cable turns a single motherboard CPU FAN header into ten 4-pin PWM connectors, letting you run up to 10 fans from one source. A SATA power plug supplies the current needed for simultaneous start-up, while the orange header is reserved for the CPU fan so its speed signal reaches the board. EVA double-sided adhesive tape is included to secure the 7.5 by 5 cm hub inside the chassis.
PWM control and dedicated CPU header
All ten ports pass the PWM signal, so fan speeds adjust automatically based on motherboard temperature curves. The orange connector carries the tachometer feedback to the CPU FAN header, ensuring the system monitors the primary cooler. A separate temperature-control cable is also supplied in the package for additional thermal management options.
Suits builders expanding air or water cooling
This hub suits PC builders who need more 4-pin fan headers than the motherboard provides, especially in custom water-cooling loops. It is not for systems that rely solely on 3-pin voltage control, nor for installations where a single SATA power connection cannot deliver enough current for the attached fans.
Highlights
- Connect up to ten 12 V PWM fans from one motherboard header
- PWM signal passes through for automatic speed control on all connected fans
- Dedicated orange CPU-fan header ensures correct RPM reporting to the motherboard
- SATA power connector supplies reliable 12 V current for all ten channels
- Compact 7.5 cm hub with adhesive backing fits neatly inside any case
Specifications
No published specifications for this item yet.
Questions about this item
Does the hub require any periodic maintenance or component replacement after installation?
The hub is a passive cable assembly with no moving parts or consumable components, so no scheduled maintenance or replacement is needed under normal use.
What is the first limit reached when all ten fans run continuously at full speed?
The total current draw of all connected fans must stay within the SATA power connector and motherboard PWM header ratings, which typically becomes the limiting factor before the hub itself.
How much heat or noise does the hub generate when the system runs all day?
The hub produces no audible noise and negligible heat because it only routes power and PWM signals without active electronics.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
