Vockjour 6ft 3-Prong AC Power Cord 18AWG 10A 125V NEMA 5-15P to C13
A 1.8 m NEMA 5-15P to C13 cord rated 10 A at 125 V, built with 18 AWG copper and an ETL-listed PVC jacket for safe, plug-and-play power
- Length6 Feet
- Connector DetailMale-to-Female
- SpecificationsVoltage: 125 volts_of_alternating_current; Current: 10 amps;
- 6 ft length gives flexible placement for desk or entertainment setups
- 10 A 125 V rating supports monitors, PCs, printers and consoles
- 18 AWG pure-copper conductors deliver low-loss power transfer
- ETL listed safety certification confirms tested compliance
- NEMA 5-15P to C13 connectors fit standard three-pin device inlets
Vockjour 6ft NEMA 5-15P to C13 Power Cord
This 6-foot AC power cord connects devices with a C13 inlet to a standard NEMA 5-15P wall outlet. It is rated for 10 amps at 125 volts and built with 18AWG conductors. The cable suits desktop computers, monitors, printers, game consoles and similar equipment that use a three-pin IEC C13 connector.
ETL-Listed Safety and 18AWG Copper Construction
The cord carries an ETL listing, confirming it has been tested for safety and compliance. Its SVT PVC jacket encloses 100 percent pure copper conductors, which provide high conductivity and low power loss during normal operation. The flexible jacket allows easy routing behind desks or entertainment units without excessive stiffness.
Universal Plug-and-Play Replacement for C13 Devices
No software or drivers are required; the cord delivers instant power once both ends are seated. The package includes only the cable itself, so buyers needing a locking C13 connector, a two-prong NEMA 1-15P plug, or alternative lengths such as 5, 9 or 12 feet must select a different variant.
Highlights
- 6 ft length gives flexible placement for desk or entertainment setups
- 10 A 125 V rating supports monitors, PCs, printers and consoles
- 18 AWG pure-copper conductors deliver low-loss power transfer
- ETL listed safety certification confirms tested compliance
- NEMA 5-15P to C13 connectors fit standard three-pin device inlets
Specifications
| Brand | Vockjour |
|---|---|
| Length | 6 Feet |
| Connector Detail | Male-to-Female |
| Specifications | Voltage: 125 volts_of_alternating_current; Current: 10 amps; Connector: Male-to-Female |
Questions about this item
How do I connect the NEMA 5-15P plug and C13 connector correctly?
Insert the three-prong NEMA 5-15P end into a standard 125 V wall outlet and the C13 end into the device inlet; the step often missed is pushing the C13 fully home until it clicks, otherwise the connection can work loose.
What wear should I watch for on the 18 AWG copper conductors and PVC jacket over time?
Inspect the cord periodically for cracked or brittle PVC, kinks near the moulded plugs, or discoloured pins; if the jacket splits or a pin feels loose, replace the cord to maintain the 10 A rating.
At what load does the 18 AWG wire hit its thermal limit during continuous use?
The cord is rated for 10 A at 125 V; running it at or near that 10 A continuously will cause the conductor to reach its design temperature first, so avoid sustained loads above 10 A.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



