Vivitek
Vivitek H1082 projector lamp 230W 5811116206-S
A 230 W replacement lamp module with housing for Vivitek H1082 projectors, rated for 2,000 to 3,000 hours depending on mode
- TypeProjector Lamp
- Wattage230W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Ready to install with pre-assembled bulb and housing
- 230W UHP lamp matches original projector specifications
- Up to 3000 hours life in economy mode
- Manufactured under ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Genuine Replacement Lamp for Vivitek Projectors
The Vivitek H1082 lamp module arrives as a new 230W UHP bulb pre-installed in its housing for direct installation. It is designed for users who need to restore original brightness to a compatible Vivitek projector without separate bulb handling. Buyers who require a bare bulb without the housing cannot use this assembly.
230W UHP Wattage Matches Original Specification
The single specification that determines fit is the 230W power rating, which must match the projector's original lamp requirement. A different wattage will cause ignition failure or damage the projector's power supply. Verify the 5811116206-S part number against your projector manual before ordering.
Rated 2,000 Hours Normal
In normal operation the lamp delivers approximately 2,000 hours of service before replacement is needed. Switching the projector to economy mode extends the rated life to 3,000 hours while reducing power draw and heat output. Typical running temperature and fan noise remain consistent with the projector's original design.
Highlights
- Ready to install with pre-assembled bulb and housing
- 230W UHP lamp matches original projector specifications
- Up to 3000 hours life in economy mode
- Manufactured under ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 230W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
How bright will the 230W lamp be in normal use?
The 230W UHP bulb delivers the original brightness for the Vivitek H1082 projector, rated for 2,000 hours in normal mode before replacement is needed.
Does the lamp module use a standard connector that fits the H1082?
Yes, the fully assembled housing matches the original 5811116206-S design and plugs directly into the projector without adapters.
Will the housing fit inside the H1082 lamp compartment?
The module is built to the exact dimensions of the genuine Vivitek H1082 lamp, so it seats correctly in the projector’s lamp door.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



