Vivitek
Vivitek DX3350 projector lamp 370W 1500 hrs
A ready-to-install 370 W P-VIP lamp module rated for 1,500 hours of use in the DX3350 projector
- TypeP-VIP
- Wattage370W
- Lamp Life1,500 hrs
- Genuine Osram P-VIP bulb delivers reliable brightness
- 370 W power matches original projector specification
- 1 500-hour rated life supports extended use
- Pre-assembled housing enables quick tool-free installation
- Manufactured to ISO 9001 quality standards
Ready-to-install module
The Vivitek DX3350 projector lamp ships as a complete 370 W P-VIP bulb inside its housing, so it fits the projector without extra assembly. It is intended for owners of the DX3350 who need a new light source that matches the original specification.
Replaces the original lamp
This unit takes the place of the factory-installed module when its 1500-hour rated life is reached or brightness drops below usable levels. The change is worth it when image quality fades or the projector signals a lamp warning.
Fits the DX3350 chassis
The module slides into the existing lamp compartment and connects to the projector's power supply without adapters. It frees the operator from sourcing a bare bulb and separate housing, keeping downtime to a single swap.
Highlights
- Genuine Osram P-VIP bulb delivers reliable brightness
- 370 W power matches original projector specification
- 1 500-hour rated life supports extended use
- Pre-assembled housing enables quick tool-free installation
- Manufactured to ISO 9001 quality standards
Specifications
| Brand | Vivitek |
|---|---|
| Type | P-VIP |
| Wattage | 370W |
| Lamp Life | 1,500 hrs |
Questions about this item
Does the 5811119760-SVV housing match the original mount points on a Vivitek DX3350?
The module is a fully assembled bulb and housing built to the original specifications, so it aligns with the factory mount points on the DX3350 projector.
What is the correct sequence for installing the 370 W lamp module without triggering a lamp-door error?
Power off and unplug the projector, allow it to cool, remove the lamp cover, release the securing screws, slide the old module out, insert the new module until it seats firmly, retighten the screws, replace the cover, then reset the lamp timer in the menu.
When should I plan to replace the Osram P-VIP 370 W bulb based on the 1 500 hour rating?
Expect approximately 1 500 hours of typical use before brightness drops to half; replace the module once the projector warns of end-of-life or image dimming becomes noticeable.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



