visiPower
visiPower 9" Sewer Inspection Camera DVR 512Hz Locator 22mm IP68 1000TVL 12 LED 40/131ft
A 22 mm IP68 camera with 12 LEDs and 145° view records to an 8 GB card on a 9" monitor with 512 Hz locator for 40 to 131 ft inspections
- Clear 1000TVL video with IP68 22mm camera
- 12 adjustable LEDs illuminate 145° view in darkness
- Record inspections to included 8GB card via DVR
- 512Hz locator pinpoints underground pipe damage accurately
- 9" monitor with sun visor for outdoor visibility
9" Sewer Inspection System with DVR
This visiPower system pairs a 9-inch LCD monitor with a 22mm IP68-rated camera probe for pipe and sewer inspection. The camera delivers 1000TVL resolution through a 145-degree viewing angle and includes 12 adjustable LEDs for illumination in dark pipes. A built-in DVR records video and photos to an included 8GB TF card.
Suited for pipe inspection up to 131ft.
The 22mm camera head and cable lengths of 40ft or 131ft suit residential and light commercial drain lines. The 512Hz transmitter helps locate the probe position from above ground. Buyers needing to inspect pipes narrower than 22mm or requiring wireless video streaming should consider other equipment.
Plug-and-play setup with padded case.
The kit arrives in a padded case with a leather sun visor for outdoor screen visibility. Connect the probe to the monitor, insert the TF card, and power on to begin recording. The most common issue is underestimating the required cable length for a specific job, so verify the 40ft or 131ft option matches the inspection distance.
Highlights
- Clear 1000TVL video with IP68 22mm camera
- 12 adjustable LEDs illuminate 145° view in darkness
- Record inspections to included 8GB card via DVR
- 512Hz locator pinpoints underground pipe damage accurately
- 9" monitor with sun visor for outdoor visibility
Specifications
No published specifications for this item yet.
Questions about this item
What power source does the 9" monitor DVR need to operate?
The monitor DVR runs from its internal rechargeable battery; charge it fully before the first inspection.
Can the 22mm camera head pass through the same bends as my existing 1/2-inch push rods?
The 22mm diameter is larger than standard 1/2-inch rods, so it will not navigate the same tight bends.
How do I confirm the 512Hz locator is detecting the camera position correctly?
Power on the locator, move it along the ground above the pipe, and watch the signal strength peak when directly over the camera head.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor Made 12" x 18" Jolly Roger Novelty Flag 1818 marine electronic
- Accessories



