We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
SATA power supply unit for 11-target duplicator

VinPower

VinPower SATA Power Supply for SharkCopier SharkBlu 11 Target Duplicator

SKU CH-CF1Z-QQ27R

SATA power supply supporting up to 11 target drives for SharkCopier and SharkBlu duplicators

  • Target1 to 11
  • Operating TypeStandalone
  • Powers up to 11 target drives simultaneously
  • SATA power delivery for SharkCopier and SharkBlu duplicators
  • Standalone operation requires no host computer connection
  • Replaces worn power supply to restore duplicator uptime

Power Supply for 11-Target Duplicator

This SATA power supply is built for the VinPower SharkCopier and SharkBlu duplicator series. It supports standalone operation for disc production environments. The unit connects directly to the duplicator chassis to drive the target drives. It is intended for IT teams and service bureaus running high-volume optical media duplication.

Capacity Covers One to Eleven Targets

The supply delivers power for configurations ranging from a single target up to the maximum eleven targets. It handles the full load of a fully populated tower without requiring additional power modules. It does not support duplicators that exceed the eleven-target limit or systems using a different power interface. Buyers needing to power larger arrays or non-SATA drive sets should look elsewhere.

Highlights

  • Powers up to 11 target drives simultaneously
  • SATA power delivery for SharkCopier and SharkBlu duplicators
  • Standalone operation requires no host computer connection
  • Replaces worn power supply to restore duplicator uptime

Specifications

Target1 to 11
Operating TypeStandalone

Questions about this item

Will this SATA power supply run the 11 target drives in my SharkBlu duplicator alongside the existing controller board?

Yes, the supply is built for Vinpower SharkCopier and SharkBlu units with up to 11 targets, so it connects directly to the same SATA power cables your current drives use.

How can I confirm the power supply is operating correctly once installed in the duplicator?

After fitting the unit, power on the duplicator; the controller should initialise all connected targets without reporting a power fault, and each drive will spin up normally during a burn cycle.

New to this? Paying with USDT: TRC-20 or ERC-20 — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.