Viking Air Tools
Viking Air Tools VT3012A Angle Die Grinder 1/4 in Collet 15000 RPM
A medium-duty right-angle die grinder with a 1/4 in collet runs at 15000 RPM from a .33 hp air motor
- MaterialHAWA
- Medium-duty grinding at 0.33 hp for controlled material removal
- Right-angle head reaches tight spots other grinders cannot
- 1/4 in collet accepts standard accessories without adapters
- 15,000 RPM top speed finishes metal and composites quickly
- 106-degree gearless design reduces vibration during extended use
Right-angle air die grinder
The Viking VT3012A is a medium-duty pneumatic tool built for grinding, deburring and polishing in tight spaces. Its 1/4 in collet accepts standard accessories while the 106-degree gearless head improves access around obstructions. The tool runs on compressed air through a 1/4 in NPT female inlet and ships as a bare unit ready for workshop use.
Sustained-load behaviour
Rated at 0.33 hp and 15,000 RPM, the grinder delivers consistent speed while air supply is maintained. The gearless design reduces internal friction so output torque stays steadier during extended material removal. A mechanical safety stop prevents accidental throttle engagement when the tool is set down between passes.
1/4 in collet capacity
The fixed 1/4 in collet determines which burrs, mounted points and sanding discs can be fitted. Users needing larger shank accessories or a 6 mm collet must choose a different model. This limitation also means the grinder is not suited for heavy stock removal that demands higher horsepower or larger-diameter cutters.
Highlights
- Medium-duty grinding at 0.33 hp for controlled material removal
- Right-angle head reaches tight spots other grinders cannot
- 1/4 in collet accepts standard accessories without adapters
- 15,000 RPM top speed finishes metal and composites quickly
- 106-degree gearless design reduces vibration during extended use
Specifications
| Brand | VIKING AIR TOOLS |
|---|---|
| Material | HAWA |
Questions about this item
How loud is the VT3012A angle die grinder during continuous operation?
The right-angle die grinder runs on compressed air at a maximum speed of 15,000 RPM with a 0.33 hp motor. Air-powered tools typically produce less motor heat than electric equivalents, but the exhaust air flow will be noticeable in a small workshop.
What air supply fittings and hose do I need to run this 1/4 in NPT female inlet tool?
You must provide a compressed-air source capable of feeding the 1/4 in NPT female inlet. A matching 1/4 in NPT male coupler on your air hose, plus a regulator and lubricator in the line, are required before the tool will operate.
Will the 106-degree right-angle head clear the same tight spaces as my older straight die grinder?
The 106-degree gearless right-angle head is significantly shorter in profile than a straight-body grinder, allowing access inside engine bays, behind brake calipers and other confined areas where a straight tool cannot reach.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
