ViewSonic
ViewSonic PJL6233 215W Projector Lamp 6000 Hrs
A 215W replacement lamp module with a 6,000-hour rated life for ViewSonic projectors
- TypeProjector Lamp
- Wattage215W
- Lamp Life6,000 Hrs.
- Ready-to-install module with bulb and housing included
- 215W UHP lamp delivers 6000 hours of rated life
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
- OEM replacement built for ViewSonic projectors
ViewSonic PJL6233 Replacement Lamp
This 215W lamp module fits ViewSonic projectors that use the PJL6233 part number. It arrives as a complete housing with a new Philips UHP bulb inside. Installation is straightforward because the assembly is pre-aligned. The unit is sold new and ready for immediate use.
Replaces worn PJL6233 modules
Swap this in when the original lamp reaches its 6,000-hour rating or when brightness drops noticeably. The jump is worth it if the projector otherwise meets your resolution and connectivity needs. It restores factory light output without requiring a new projector purchase.
6,000-hour rated life at 215W
The lamp delivers consistent illumination for typical meeting-room or classroom schedules across its rated span. It runs out when the hour counter hits the limit or when colour uniformity degrades beyond adjustment. Heavy daily use will reach the limit sooner than occasional sessions.
Highlights
- Ready-to-install module with bulb and housing included
- 215W UHP lamp delivers 6000 hours of rated life
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
- OEM replacement built for ViewSonic projectors
Specifications
| Brand | ViewSonic |
|---|---|
| Type | Projector Lamp |
| Wattage | 215W |
| Lamp Life | 6,000 Hrs. |
Questions about this item
Does the PJL6233 lamp module ship as a complete housing so it fits the projector without extra parts?
Yes, the PJL6233 arrives as a fully assembled 215 W bulb inside its housing, matching the original RLC-065 form factor for direct installation.
What is the correct sequence for installing the PJL6233 lamp, and which step do users most often miss?
Power off and unplug the projector, let it cool completely, remove the lamp cover, release the retaining screws, slide the old module out, insert the new PJL6233 until it seats firmly, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most frequently forgotten.
After roughly 6000 hours of use, what part of the PJL6233 will need replacement?
The entire PJL6233 lamp module is rated for 6000 hours; once the bulb reaches that limit you replace the complete housing assembly rather than the bare bulb alone.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



