We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
ViewSonic PJ560DC projector lamp module with 180W bulb in housing

ViewSonic

ViewSonic PJ560DC projector lamp 180W 2000 hrs

SKU CH-300H-EA9A5

A complete 180W UHP lamp module rated for 2000 hours, supplied with housing for direct installation

  • TypeProjector Lamp
  • Wattage180W
  • Lamp Life2,000 Hrs.
  • Ready-to-install module saves setup time
  • 180W UHP bulb matches original brightness
  • 2,000-hour rated life extends replacement interval
  • ISO 9001 manufacturing ensures consistent quality
  • Genuine OEM bulb options from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita

ViewSonic PJ560DC 180W replacement lamp

This new 180W UHP lamp module includes the bulb and housing fully assembled for direct installation in compatible ViewSonic projectors. It restores original brightness without requiring separate alignment or tools. The unit is manufactured to ISO 9001 quality standards and supplied as an OEM or compatible version depending on stock. Buyers receive a ready-to-fit light engine rather than a bare bulb.

2000-hour rated life and 180W output

The lamp is rated for 2000 hours of typical use before brightness drops to half its initial level. At 180W it matches the projector's designed power draw, so colour balance and fan curves remain unchanged. Heavy daily use will reach the limit faster than occasional presentations, and eco modes can extend the interval. The module does not add extra headroom beyond the factory specification.

Replaces POA-LMP118 module in supported models

This lamp replaces the ViewSonic POA-LMP118 assembly when the original reaches end of life or fails to ignite. The swap is worthwhile when image dimming, flicker or a lamp-warning message appears. It is not for users seeking higher lumen output, different colour temperature or a longer-rated alternative, as the specifications match the original design exactly.

Highlights

  • Ready-to-install module saves setup time
  • 180W UHP bulb matches original brightness
  • 2,000-hour rated life extends replacement interval
  • ISO 9001 manufacturing ensures consistent quality
  • Genuine OEM bulb options from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita

Specifications

BrandViewSonic
TypeProjector Lamp
Wattage180W
Lamp Life2,000 Hrs.

Questions about this item

Will the 180 W PJ560DC lamp fit the same housing as the original POA-LMP118 module in my older ViewSonic projector?

The PJ560DC is a fully assembled 180 W bulb-and-housing module built to the POA-LMP118 specification, so it installs directly into the same projector slot without adapters.

How can I confirm the new lamp is igniting and running at the rated 180 W after installation?

Check the projector’s on-screen lamp-hour counter; it should reset to zero and then increment normally, while the image reaches full brightness without flicker or colour shift.

Does the box contain only the lamp module or are extra cables or filters included?

The package supplies the complete 180 W UHP lamp inside its housing, ready to fit; no separate cables, filters or tools are bundled.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.