ViewSonic
ViewSonic PJ558 OEM Replacement Projector Lamp 230W
A 230W replacement lamp module with Ushio NSHA bulb and housing, rated for 2000 to 3000 hours of projector use
- TypeProjector Lamp
- Wattage230W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Ready to install with pre-assembled bulb and housing
- 230W Ushio NSHA bulb matches original brightness
- 2000 hours normal mode or 3000 hours economy
- Manufactured to ISO 9001 quality standards
- Tested for beam performance ignition voltage and run-time
Ready-to-install lamp module
The ViewSonic PJ558 replacement lamp arrives as a complete 230W bulb-and-housing assembly manufactured to ISO 9001 standards. It uses a genuine Ushio NSHA bulb and is built for direct installation in compatible ViewSonic projectors without additional tools or alignment steps.
OEM-grade build and daily handling
Each unit undergoes strict quality checks covering beam performance, ignition voltage, connections and run-time before it ships. The pre-assembled housing means you simply swap the old module and resume presentations or lessons without recalibrating the projector.
Restores original brightness and runtime
The lamp delivers 2,000 hours in normal mode and up to 3,000 hours in economy mode, matching the projector’s factory specifications. It is not suited for users who need longer-rated lamps or higher-wattage output than the 230W design provides.
Highlights
- Ready to install with pre-assembled bulb and housing
- 230W Ushio NSHA bulb matches original brightness
- 2000 hours normal mode or 3000 hours economy
- Manufactured to ISO 9001 quality standards
- Tested for beam performance ignition voltage and run-time
Specifications
| Brand | ViewSonic |
|---|---|
| Type | Projector Lamp |
| Wattage | 230W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
Does the PJ558 lamp module include the housing for direct installation?
Yes, the PJ558 lamp module is supplied as a fully assembled bulb and housing, so it fits straight into the projector without extra assembly.
What are the physical dimensions and mounting points of the PJ558 housing?
The PJ558 housing is built to match the original ViewSonic VLT-XD420LP form factor, aligning with the projector’s existing latch and screw positions for a secure fit.
What is the correct reset procedure after installing the PJ558 lamp?
After fitting the new 230W lamp, access the projector’s menu and reset the lamp-hour counter to zero; skipping this step leaves the timer stuck at the old value.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



