ViewSonic
ViewSonic PJ513 Projector Lamp 200W Philips UHP 3500 4000 Hrs
Replacement 200W projector lamp module with Philips UHP bulb rated for 3,500 normal or 4,000 economy hours
- TypeProjector Lamp
- Wattage200W
- Lamp Life3,500 (Normal) - 4,000 (Economy) Hrs.
- Ready-to-install module with genuine Philips UHP 200W bulb
- Up to 4000 hours lamp life in Economy mode
- 3500 hours rated life in Normal brightness mode
- Manufactured to ISO 9001 quality standards
- Direct OEM replacement for ViewSonic PJ513 projectors
Direct OEM Replacement Lamp
The ViewSonic PJ513 lamp module arrives as a complete 200W Philips UHP bulb pre-fitted in its housing, so it installs in seconds without extra tools. It matches the original specifications for compatible ViewSonic projectors and is supplied new.
Restores Original Brightness and Runtime
Replacing a dimmed or expired lamp with this unit returns the projector to its factory light output and rated lifetime of 3500 hours in normal mode or 4000 hours in economy mode. The swap is worthwhile when image quality has faded or the projector warns that the lamp is near its end.
Consistent Output Through Extended Sessions
Built to ISO9001 quality checks for ignition, voltage stability and run-time, the lamp maintains steady brightness during long presentations or film marathons rather than fading after a short burst. Each unit is tested for beam performance before it ships.
Highlights
- Ready-to-install module with genuine Philips UHP 200W bulb
- Up to 4000 hours lamp life in Economy mode
- 3500 hours rated life in Normal brightness mode
- Manufactured to ISO 9001 quality standards
- Direct OEM replacement for ViewSonic PJ513 projectors
Specifications
| Brand | ViewSonic |
|---|---|
| Type | Projector Lamp |
| Wattage | 200W |
| Lamp Life | 3,500 (Normal) - 4,000 (Economy) Hrs. |
Questions about this item
Which ViewSonic projector models accept the PJ513 lamp module?
The PJ513 lamp is designed as a direct replacement for ViewSonic projectors that use the RLC-035 module.
What is the correct sequence for installing the PJ513 lamp and resetting the hour counter?
Power off and unplug the projector, allow it to cool, remove the old lamp housing, insert the new PJ513 module, secure the retaining screws, then reset the lamp timer in the on-screen menu.
When should I plan to replace the PJ513 lamp based on its rated life?
The lamp is rated for 3500 hours in normal mode and 4000 hours in economy mode; replace it when the projector warns of end-of-life or brightness drops noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



