ViewSonic
ViewSonic ImagePro 8044 Projector Lamp 130W 2000 Hrs
Genuine compatible replacement lamp with 130W UHB bulb and housing, rated for 2000 hours
- TypeProjector Lamp
- Wattage130W
- Lamp Life2,000 Hrs.
- Genuine 130W UHB bulb delivers reliable brightness
- 2000-hour lamp life supports extended projector use
- Pre-assembled bulb and housing enable quick installation
- ISO 9001 manufacturing ensures consistent quality control
- Compatible with ViewSonic ImagePro 8044 model DT00581
Genuine Replacement Lamp Module
The ViewSonic ImagePro 8044 module supplies a new 130W UHB bulb inside a pre-assembled housing that matches the original DT00581 specification. It is built for owners of compatible ViewSonic projectors who need a direct swap without separate bulb handling. Installation is straightforward because the lamp ships as a complete unit.
Rated Output and Service Life
The 130W bulb delivers the brightness the projector was designed for and is rated for 2000 hours of typical use before brightness drops to half. Heavy daily operation will reach that limit sooner, while occasional use extends the practical interval. The module restores original image quality for the duration of its rated life.
Compatibility and Quality Assurance
Each unit is produced under ISO9001 controls and tested for ignition, voltage, beam performance and run-time to ensure reliable operation in the target projector. Buyers whose projectors require a different wattage, connector or form factor cannot use this module. The 90-day warranty period covers early failures but does not extend the rated lamp life.
Highlights
- Genuine 130W UHB bulb delivers reliable brightness
- 2000-hour lamp life supports extended projector use
- Pre-assembled bulb and housing enable quick installation
- ISO 9001 manufacturing ensures consistent quality control
- Compatible with ViewSonic ImagePro 8044 model DT00581
Specifications
| Brand | ViewSonic |
|---|---|
| Type | Projector Lamp |
| Wattage | 130W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Will the 130W UHB lamp run correctly in my existing ImagePro 8044 projector without any firmware update?
The module is a direct replacement built to the projector's original 130W specification, so it installs and operates without firmware changes.
How can I verify the new lamp is performing at the rated 2,000-hour life after installation?
Reset the projector's lamp-hour counter on install; the counter will then track usage toward the 2,000-hour rating and the projector will warn you when replacement is due.
Does the DT00581 module ship as a complete housing so I do not need to buy a separate cage or tools?
Yes, the bulb comes pre-assembled in its housing, ready to fit into the ImagePro 8044 with no extra parts or tools required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



