We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee, 2" x 2" x 1-1/2", press-fit ends, EPDM O-rings, rolled centre stop

Viega

Viega ProPress 2918 Copper Tee 2 in x 2 in x 1 1/2 in

SKU CH-Z9HP-SZ9CW

A copper reducing tee with press-fit connections on all three ends for potable-water systems rated to 200 psi

  • ProPress press-fit joints install without soldering or open flame
  • Reducing tee joins 2 in, 2 in and 1 1/2 in copper tubes in one fitting
  • EPDM O-ring seal rated for 200 psi potable-water pressure
  • Factory-rolled center stop ensures correct tube insertion depth every time
  • Copper construction resists corrosion for long service life

Viega ProPress 2918 Copper Reducing Tee

This Viega ProPress 2918 copper tee connects three press-fit lines in potable-water systems. The reducing shape joins two 2-inch copper tubes and one 1-1/2-inch tube with a rolled centre stop. EPDM O-rings seal each press-fit connection without solder or flame. The fitting is new and rated for standard plumbing service.

Press-fit interface limits at 200 psi

The press-fit joints hold up to 200 psi maximum operating pressure in potable-water applications. Copper tube dimensions must match the listed sizes exactly for a secure crimp. EPDM seals suit hot and cold water but are not rated for oil, fuel or aggressive chemicals. No threading or soldering is required or supported on any port.

Tool-dependent install with jaw-size risk

Installation requires a compatible press tool and correctly sized jaws for each tube diameter. The most common error is using mismatched or worn jaws, which leaves an incomplete crimp and a leak path. Debris on tube ends or damaged O-rings also cause seal failure. Always pressure-test the assembly before concealing the joint.

Highlights

  • ProPress press-fit joints install without soldering or open flame
  • Reducing tee joins 2 in, 2 in and 1 1/2 in copper tubes in one fitting
  • EPDM O-ring seal rated for 200 psi potable-water pressure
  • Factory-rolled center stop ensures correct tube insertion depth every time
  • Copper construction resists corrosion for long service life

Specifications

BrandViega

Questions about this item

Should I pick the 2 in x 2 in x 1 1/2 in reducing tee or a straight tee for my branch line?

Choose this reducing tee when the branch line is 1 1/2 in copper tube while the run stays at 2 in; a straight tee would require a separate reducer fitting.

What does the 200 psi maximum operating pressure mean once the fitting is pressed onto copper tube?

The pressed joint is rated for continuous service up to 200 psi in potable water systems, so the fitting will not be the pressure-limiting component in typical residential or commercial supplies.

How does the ProPress press-fit interface affect installation time compared with soldered tees?

The press-fit connection eliminates flux, solder and open flame, so a qualified installer can complete each joint in seconds once the press tool is calibrated.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.