We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper tee fitting with three press-fit ends and rolled center stop

Viega

Viega ProPress 2918 Copper Tee 1-1/4 in

SKU CH-ACWK-KXGKG

Connects three 1-1/4 in copper tubes with press-fit EPDM-sealed joints rated to 200 psi

  • Item Count1
  • Press-fit connections install without flame or solder
  • Three 1-1/4 in ports simplify branch routing
  • EPDM O-ring seals rated to 200 psi
  • Rolled center stop ensures correct insertion depth
  • Copper construction resists corrosion in potable water

Copper press-fit tee for potable water

The Viega ProPress 2918 is a 1-1/4 inch copper tee with press-fit connections on all three ports. It is designed for potable-water systems where a secure, flame-free joint is required. The fitting includes a rolled center stop and EPDM O-rings for reliable sealing.

Replaces soldered or threaded copper tees

This fitting replaces traditional soldered or threaded copper tees in 1-1/4 inch lines. The jump is worth it when installation speed matters, when open flames are prohibited on site, or when a consistent mechanical seal is preferred over solder quality. It handles a maximum operating pressure of 200 psi.

Press-tool installation with visual verification

Installation uses a compatible press tool to crimp each port, eliminating the need for flux, solder or pipe dope. The rolled center stop ensures correct tube insertion depth. What usually goes wrong is pressing with the wrong jaw size or skipping the visual check that each press ring is fully seated.

Highlights

  • Press-fit connections install without flame or solder
  • Three 1-1/4 in ports simplify branch routing
  • EPDM O-ring seals rated to 200 psi
  • Rolled center stop ensures correct insertion depth
  • Copper construction resists corrosion in potable water

Specifications

Item Count1
BrandViega

Questions about this item

What copper tube size does the 1-1/4 in ProPress tee accept on each port?

Each of the three press-fit ports is sized for 1-1/4 in copper tube, matching the 1-1/4 in CTS dimension.

Which press tool jaw profile is required to install this copper tee correctly?

Use a Viega ProPress jaw set for 1-1/4 in copper; the tool must fully close the jaw around the fitting bead to seat the EPDM O-ring.

When should the EPDM O-rings inside this tee be inspected or replaced?

Inspect the O-rings during any system pressure test or after 200 psi operating cycles; replace if they show cracking, flattening or leakage.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.