We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee, press-fit ends, matte finish

Viega

Viega ProPress 2918 Copper Reducing Tee 2" x 1-1/2" x 1-1/2

SKU CH-29ER-KXTBC

Copper reducing tee joins 2 in and 1-1/2 in lines with press-fit EPDM seals rated to 200 psi

  • Press-fit connections install without soldering or open flame
  • Reducing tee joins 2 in to two 1-1/2 in branches in one fitting
  • EPDM O-ring seals potable water systems up to 200 psi
  • Built-in center stop dimple ensures correct tube insertion depth
  • Copper construction resists corrosion for long service life

Copper reducing tee for press-fit plumbing

The Viega ProPress 2918 is a copper reducing tee with press-fit connections on all three outlets. Side A accepts 2 in copper tube while sides B and C each accept 1 1/2 in tube. An EPDM O-ring and a centre-stop dimple are included for a secure, leak-free joint rated to 200 psi maximum operating pressure.

Replaces soldered or threaded copper tees

This fitting eliminates the need for open-flame soldering or pipe threading on potable-water lines. The press-fit method cuts installation time and reduces fire-risk on site. The jump is worth it when a project demands faster assembly, cleaner joints or compliance with no-flame workplace policies.

Suits installers working

Plumbers and mechanical contractors who regularly reduce from 2 in mains to 1 1/2 in branches will find the dimensions match that exact step-down. Installers needing other size combinations, non-copper materials or threaded ends should look at alternative fitting configurations.

Highlights

  • Press-fit connections install without soldering or open flame
  • Reducing tee joins 2 in to two 1-1/2 in branches in one fitting
  • EPDM O-ring seals potable water systems up to 200 psi
  • Built-in center stop dimple ensures correct tube insertion depth
  • Copper construction resists corrosion for long service life

Specifications

BrandViega

Questions about this item

What copper tube sizes does the 2918 reducing tee accept on each port?

The tee accepts 2 in on the run and 1-1/2 in on both the branch and the other run port.

How do I install the ProPress tee and what step is often missed?

Cut tube square, deburr, mark insertion depth, press with a compatible jaw — the step often missed is verifying the mark is still visible after pressing.

When should the EPDM O-rings be inspected or replaced?

Inspect O-rings during any system service or if leakage appears; replace if they show cracking, hardening or permanent deformation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.