We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee with three press-fit ends, EPDM O-rings, centre stop dimple

Viega

Viega ProPress 2918 Copper Reducing Tee 1 x 3/4 x 1 in

SKU CH-P7VJ-880PY

Copper reducing tee with press-fit connections for potable water systems, rated to 200 psi

  • Press-fit copper tee joins 1 in, 3/4 in and 1 in lines without soldering
  • EPDM O-ring seals potable water at up to 200 psi working pressure
  • Centre-stop dimple seats each tube at the correct depth for reliable joints
  • Reducing tee shape connects three sizes in one compact 3 15/16 in fitting
  • Copper construction resists corrosion for long service in plumbing systems

ProPress 2918 Reducing Tee

The Viega ProPress 2918 is a copper reducing tee designed for potable water systems. It connects a 1 inch run to a 3/4 inch branch using press-fit ends on all three outlets. The fitting carries a maximum operating pressure of 200 psi.

Copper Construction With EPDM Seal

The body is made from copper and includes an EPDM O-ring at each press connection. A centre stop dimple helps confirm full insertion during installation. The overall length measures 3 15/16 in, keeping the joint compact inside walls or cabinets.

Replaces Soldered Reducing Tees

This press fitting removes the need for open flame, flux and solder when joining copper tube. It is suited to projects where hot-work permits are difficult or where speed on site matters. Installers who prefer traditional brazed joints will not gain the press-tool workflow.

Highlights

  • Press-fit copper tee joins 1 in, 3/4 in and 1 in lines without soldering
  • EPDM O-ring seals potable water at up to 200 psi working pressure
  • Centre-stop dimple seats each tube at the correct depth for reliable joints
  • Reducing tee shape connects three sizes in one compact 3 15/16 in fitting
  • Copper construction resists corrosion for long service in plumbing systems

Specifications

BrandViega

Questions about this item

What pressure does the ProPress 2918 press-fit connection hold?

The press-fit joints are rated for a maximum operating pressure of 200 psi in potable-water systems.

What tube sizes and clearance does the 1 x 3/4 x 1 in tee require?

It connects 1 in, 3/4 in and 1 in copper tube and has an overall length of 3 15/16 in with a center stop dimple.

How is the Viega 2918 tee installed and what step is often missed?

Insert each tube fully until it hits the center stop dimple, then press all three joints with a ProPress tool; skipping full insertion causes leaks.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.