We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee with three press-fit ends, two larger one smaller

Viega

Viega ProPress 2918 Copper Reducing Tee 1-1/4 x 1-1/4 x 1

SKU CH-Z605-JCKN8

Copper reducing tee with press-fit connections for 1-1/4 and 1 inch tube, rated to 200 psi

  • Reducing tee joins 1-1/4" and 1" copper lines
  • Press-fit connections install without soldering or flame
  • EPDM O-ring seals potable water up to 200 psi
  • Rolled center stop ensures correct insertion depth
  • Copper construction resists corrosion for long service life

ProPress 2918 reducing tee for potable water

The Viega ProPress 2918 is a copper reducing tee designed for potable-water systems. Three press-fit ends join 1-1/4 in, 1-1/4 in and 1 in copper tubing without solder or flame. An EPDM O-ring on each port seals against leaks. The fitting is rated for 200 psi maximum operating pressure.

Rolled center stop and press-fit ends speed

A rolled center stop sets tube insertion depth automatically, so the joint is consistent every time. Press-fit connections remove the need for torches, flux or open flame on site. Copper construction resists corrosion in domestic hot and cold water lines. Overall length is 3 13/16 in for compact routing.

Reducing branch drops from 1-1/4 in to 1 in

The single specification that decides fit is the branch size: one port reduces from 1-1/4 in to 1 in copper tube. If your design calls for a straight 1-1/4 in tee or a different reduction, this part will not match. Confirm the branch diameter before ordering.

Highlights

  • Reducing tee joins 1-1/4" and 1" copper lines
  • Press-fit connections install without soldering or flame
  • EPDM O-ring seals potable water up to 200 psi
  • Rolled center stop ensures correct insertion depth
  • Copper construction resists corrosion for long service life

Specifications

BrandViega

Questions about this item

What press-fit standard does the ProPress 2918 tee use and what pressure does it handle?

The tee uses Viega ProPress press-fit connections on all three sides and is rated for a maximum operating pressure of 200 psi.

What tube sizes and overall length must the space accommodate for this reducing tee?

It connects two 1-1/4 in copper tubes and one 1 in copper tube, with an overall length of 3 13/16 in.

How is the ProPress 2918 tee installed and which step is commonly missed?

Insert each tube fully until it contacts the rolled center stop, then press with a compatible ProPress jaw; the step often missed is verifying full insertion before pressing.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.