Viega
Viega ProPress 2918 Copper Reducing Tee 1-1/2" x 1-1/2" x 3/4
Copper reducing tee joins three press-fit connections for potable water at up to 200 psi
- Press-fit joints install without soldering or open flame
- Reducing tee connects 1-1/2" and 3/4" copper lines in one fitting
- EPDM O-ring seals up to 200 psi operating pressure
- Rolled centre stop ensures correct tube insertion depth
- Copper construction resists corrosion in potable water systems
ProPress 2918 Reducing Tee
The Viega ProPress 2918 is a copper reducing tee designed for press-fit connections on all three ports. It joins two 1-1/2 inch copper tubes with a 3/4 inch branch for potable water systems. A rolled center stop and EPDM O-ring are included to ensure proper insertion depth and a reliable seal. The fitting handles a maximum operating pressure of 200 psi.
Installers needing a 1-1/2 inch to 3/4 inch branch
This fitting suits plumbers who require a press-to-press transition from a 1-1/2 inch main line to a smaller 3/4 inch outlet without soldering. It is not for installers who need a straight coupling or a tee with three equal outlets. Builders working with non-copper piping or threaded connections must select a different fitting type.
200 psi potable water capacity
The copper body and EPDM seals are rated for 200 psi in potable water applications, providing ample headroom for typical residential and commercial supply pressures. The 1-1/2 inch run ports maintain full flow on the main line while the 3/4 inch branch supplies fixtures or smaller distribution lines. Systems exceeding the rated pressure or using incompatible fluids fall outside the approved service range.
Highlights
- Press-fit joints install without soldering or open flame
- Reducing tee connects 1-1/2" and 3/4" copper lines in one fitting
- EPDM O-ring seals up to 200 psi operating pressure
- Rolled centre stop ensures correct tube insertion depth
- Copper construction resists corrosion in potable water systems
Specifications
| Brand | Viega |
|---|
Questions about this item
What pipe sizes must I already have to connect this reducing tee?
You need 1-1/2 inch copper tube for the two straight ports and 3/4 inch copper tube for the branch port; all three connections are press-fit.
Will this tee join directly to my existing 1-1/2 inch and 3/4 inch copper lines without adapters?
Yes, the press-fit ends match standard 1-1/2 inch and 3/4 inch copper tube sizes, so no threaded or solder adapters are required.
How can I confirm the press connections are secure after installation?
Check that each pressed bead is fully formed around the tube and the rolled center stop is seated; then pressure-test the system up to 200 psi.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
