We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Bronze tee fitting with press-fit ends and threaded branch

Viega

Viega ProPress 2917.2ZL Bronze Tee 1-1/2 x 1-1/2 x 3/4

SKU CH-DCR2-XXPKV

Bronze reducing tee joins two 1-1/2" press-fit lines with a 3/4" FNPT branch, rated to 200 psi for potable water

  • ProPress press-fit connection eliminates open-flame soldering on 1-1/2" copper lines
  • Bronze body with EPDM O-ring rated for 200 psi potable-water service
  • Reducing tee splits 1-1/2" run to 3/4" FNPT branch without extra adapters
  • Center-stop dimple on each press end ensures correct insertion depth every time
  • 4 23/32 in overall length fits tight mechanical-room layouts

Bronze Reducing Tee for Press-Fit Copper Systems

This Viega ProPress bronze tee joins two 1-1/2 inch copper tubes with a 3/4 inch FNPT branch. It is intended for potable-water installations where a secure, flame-free press connection is required. The EPDM O-ring provides a watertight seal without soldering.

Sustained Pressure Performance

Rated for a maximum operating pressure of 200 psi, the fitting maintains its seal under continuous system pressure. The centre-stop dimple ensures consistent insertion depth on every press, reducing the risk of leaks during long-term service. The bronze body resists corrosion in hot and cold water circuits.

Connection Configuration Decides Fit

The specific combination of dual 1-1/2 inch press ends and a single 3/4 inch female NPT outlet determines whether this tee matches the piping layout. Installers must verify the branch size and thread type before pressing. The overall length is 4 23/32 inches.

Highlights

  • ProPress press-fit connection eliminates open-flame soldering on 1-1/2" copper lines
  • Bronze body with EPDM O-ring rated for 200 psi potable-water service
  • Reducing tee splits 1-1/2" run to 3/4" FNPT branch without extra adapters
  • Center-stop dimple on each press end ensures correct insertion depth every time
  • 4 23/32 in overall length fits tight mechanical-room layouts

Specifications

BrandViega

Questions about this item

How much pressure can the bronze tee handle when the system runs all day at 200 psi?

The fitting is rated for a maximum operating pressure of 200 psi, so continuous daily operation at that pressure is within its design limit.

Which press tool and jaw size are required to install the 1-1/2 inch press-fit ends?

You need a compatible press tool equipped with 1-1/2 inch jaws for the copper tube size connections on sides A and B.

Will the EPDM O-ring seal reliably against older copper pipe that has surface oxidation?

The EPDM O-ring is designed for potable water systems and seals on clean, properly prepared copper tube; heavy oxidation should be removed before pressing.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.