We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper press-fit reducer, 2 in to 1 in, straight EPDM-sealed body

Viega

Viega ProPress 2915.2 Copper Reducer 2 in x 1 in

SKU CH-X6G2-4WGY3

Connects 2 in and 1 in copper tubing with press-fit ends, EPDM seal, rated to 200 psi at 250 °F

  • Press-fit ends install fast without soldering
  • EPDM O-ring seals reliably up to 200 psi
  • Copper body handles water temperatures to 250 Degrees F
  • Straight reducing connector joins 2 in to 1 in tube
  • 3 25/32 in overall length fits tight spaces

ProPress 2915.2 Copper Reducer 2 in x 1 in

This Viega ProPress 2915.2 is a straight reducing connector that joins 2-inch copper tube to 1-inch copper tube using press-fit connections on both ends. The body is copper with an EPDM O-ring and measures 3 25/32 in overall length. It is rated for 200 psi maximum operating pressure and 250 Degrees F maximum operating temperature.

Installers needing a 2-to-1 copper reduction

The fitting suits potable-water systems where a press-tool connection is preferred and the pipe sizes match the 2-inch and 1-inch copper tube specifications. It will not suit installations that require threaded, soldered, flanged or push-fit ends, nor applications exceeding the stated pressure or temperature limits.

Press-fit connection on both ends

The defining specification is the press-fit connection type for Side A and Side B, which dictates the required tool and jaw set for a watertight seal. Verify that your press equipment supports the 2-inch and 1-inch copper tube sizes before purchase.

Highlights

  • Press-fit ends install fast without soldering
  • EPDM O-ring seals reliably up to 200 psi
  • Copper body handles water temperatures to 250 Degrees F
  • Straight reducing connector joins 2 in to 1 in tube
  • 3 25/32 in overall length fits tight spaces

Specifications

BrandViega

Questions about this item

What copper tube sizes must already be in place for the 2 in x 1 in ProPress reducer to connect?

The reducer joins a 2 in copper tube on one end and a 1 in copper tube on the other, both using press-fit connections.

Will the EPDM O-ring on this reducer hold up against existing copper piping that has seen 250 Degrees F water?

Yes, the EPDM O-ring is rated for a maximum operating temperature of 250 Degrees F, matching the fitting's overall temperature limit.

After pressing the joints, what pressure reading confirms the reducer is sealed to its rated limit?

The fitting is rated for a maximum operating pressure of 200 psi; a test at or below that pressure with no leaks confirms a proper seal.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.