We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Viega ProPress copper reducer 3/4 to 1 inch straight fitting with press and FTG ends

Viega

Viega ProPress 2915.1 copper reducer 3/4 x 1 in

SKU CH-MD0Y-PZZX7

Copper straight reducing adapter joins 1 in and 3/4 in tubing with press-fit and FTG ends, rated to 200 psi and 250 °F

  • Connects 3/4 in and 1 in copper tube sizes
  • EPDM O-ring resists corrosion in potable water systems
  • Crimp press-fit design enables fast, tool-based installation
  • Rated for 200 psi and 250 °F operating conditions
  • Meets ASTM B75 and ASTM B88 quality standards

Copper Reducer for 3/4 in to 1 in Press Connections

This Viega ProPress 2915.1 copper reducer joins a 3/4 in press-fit tube to a 1 in FTG connection in potable-water systems. The straight reducing adapter uses an EPDM O-ring and meets ASTM B75 and ASTM B88 standards. It is rated for 200 psi maximum operating pressure and 250 Degrees F maximum operating temperature. Overall length is 2 5/16 in.

Suited for Press-Fit Copper Installations

Installers who need a permanent, flameless transition between 3/4 in and 1 in copper tube sizes will use this fitting. It is not for threaded, soldered or push-fit joint methods. Buyers who require a different tube-size combination or a fitting with bolt holes or a flange should select another product.

Verify Tube Sizes and Press Tool Compatibility

Confirm the existing pipe runs use 3/4 in and 1 in copper tube sizes matching the FTG and press-fit ends. Ensure the press tool and jaw set are approved for Viega ProPress copper fittings. Check that system pressure and temperature stay within the 200 psi and 250 Degrees F limits before ordering.

Highlights

  • Connects 3/4 in and 1 in copper tube sizes
  • EPDM O-ring resists corrosion in potable water systems
  • Crimp press-fit design enables fast, tool-based installation
  • Rated for 200 psi and 250 °F operating conditions
  • Meets ASTM B75 and ASTM B88 quality standards

Specifications

BrandViega

Questions about this item

Does this reducer need a ProPress press tool and 1 in and 3/4 in jaw sets to install?

Yes, the press-fit end requires a compatible ProPress tool with the correct jaw sizes for 1 in and 3/4 in copper tube.

Can the FTG end of this fitting slide into a standard 1 in copper coupling already in the line?

The FTG end is sized for 1 in copper tube and fits inside a 1 in copper coupling or street fitting.

How can I verify the joint is sealed after pressing the 3/4 in end?

Press the fitting until the tool completes its cycle, then pressure-test the system up to 200 psi and check for leaks at 250 Degrees F max.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.