We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper 45 degree elbow press fitting with EPDM O-ring

Viega

Viega Propress 1/2" 45° Copper Elbow Double Press

SKU CH-AHWG-G9085

A 45-degree copper elbow joins two 1/2-inch tubes with double press-fit connections, rated to 200 psi and 250°F for potable water

  • Item Count1
  • Press-fit copper elbow installs fast without soldering
  • 45-degree turn routes pipe smoothly in tight spaces
  • Double press connections seal both ends in one operation
  • Rated 200 psi and 250°F for potable water systems
  • Meets ASTM B75 and B88 standards for copper quality

ProPress 1/2" Copper Elbow

The Viega ProPress fitting joins two 1/2-inch copper tubes at a 45-degree angle using a press-fit connection on both ends. It is designed for potable water systems and carries ASTM B75 and B88 compliance for material quality.

200 psi Pressure and 250 °F Rating

The copper body and EPDM O-ring handle continuous operating pressure up to 200 psi and water temperatures up to 250 degrees Fahrenheit. These limits define the safe envelope for residential and light commercial hot-water distribution.

Press-Tool Installation, No Flame Required

The double press ends accept a compatible ProPress jaw tool, eliminating the need for solder, flux or open flame during assembly. This speeds up rough-in work and reduces fire-risk paperwork on occupied job sites.

Highlights

  • Press-fit copper elbow installs fast without soldering
  • 45-degree turn routes pipe smoothly in tight spaces
  • Double press connections seal both ends in one operation
  • Rated 200 psi and 250°F for potable water systems
  • Meets ASTM B75 and B88 standards for copper quality

Specifications

Item Count1
BrandViega

Questions about this item

Will this 1/2" ProPress elbow join directly to my existing 1/2" copper pipe without extra fittings?

Yes, both ends accept 1/2 in copper tube and form a leak-free joint when pressed with a compatible ProPress tool.

How can I confirm the joint is watertight after pressing?

Pressurise the line up to 200 psi and inspect each connection; a correct press leaves no visible gaps and holds pressure at the rated 250 °F limit.

Does the elbow come with the EPDM sealing rings already installed, or must I buy them separately?

The EPDM rings are factory-fitted inside both press ends, so nothing extra is required for a standard potable-water installation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.