Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.0094001BTC
In stock
Viega
Viega Megapress Stainless 304 Coupling 1" No Stop bath hardware 95320
Stainless-steel 304 press-fit coupling joins two 1 in tubes for non-potable water up to 200 psi and 250 °F
- Press-fit coupling joins 1 in pipes without welding
- 304 stainless steel resists corrosion in non-potable water systems
- FKM O-ring seals up to 200 psi at 250 Degrees F
- Straight connector design simplifies in-line installations
- 3 9/32 in overall length fits tight plumbing spaces
Stainless 304 Press-Fit Coupling
The Viega Megapress coupling joins two 1-inch tubes with a press-fit connection on each end. Made from grade 304 stainless steel, it is rated for non-potable water systems up to 200 psi and 250 degrees Fahrenheit. The straight connector measures 3 9/32 inches overall and uses an FKM O-ring for sealing.
Replaces threaded or welded joints
This fitting eliminates the need for pipe threading or welding equipment on 1-inch stainless lines. The jump is worth it when installation speed, flame-free work sites or consistent press-tool repeatability matter more than the cost of the tool itself. It does not suit potable water circuits or applications exceeding the stated pressure and temperature limits.
Press-tool installation only
A compatible press tool and the correct jaw for 1-inch tube are required; hand-tightening or adhesive will not seal the joint. The most common failure is an incomplete press that leaves the O-ring uncompressed, so verify the tool calibration and jaw condition before every connection. No bolt holes or flanges are present to aid alignment.
Highlights
- Press-fit coupling joins 1 in pipes without welding
- 304 stainless steel resists corrosion in non-potable water systems
- FKM O-ring seals up to 200 psi at 250 Degrees F
- Straight connector design simplifies in-line installations
- 3 9/32 in overall length fits tight plumbing spaces
Specifications
| Brand | Viega Megapress Stainless 304 |
|---|
Questions about this item
What press-jaw size matches the 1 in tube ends on this 304 stainless coupling?
Use a 1 in press jaw rated for Megapress stainless fittings; the coupling has 1 in press-fit connections on both sides and an overall length of 3 9/32 in.
Which step do installers most often miss when pressing this FKM O-ring fitting?
They forget to check the FKM O-ring seating and to mark the 1 in insertion depth before pressing; an incomplete press leaves a leak path at 200 psi.
When should the FKM O-ring on this 304 stainless coupling be inspected or replaced?
Inspect the FKM O-ring at each system service or if the line sees temperatures near 250 °F; replace it at any sign of hardening, cracking or permanent compression set.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
