We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Stainless steel 45 degree street elbow press fitting with FKM O-ring

Viega

Viega MegaPress 45 street elbow 1/2" 95080

SKU CH-8K15-28NCQ

Stainless-steel 45-degree press-fit street elbow joins 1/2 in pipe to a 1/2 in fitting at up to 200 psi

  • MaterialHAWA
  • Press-fit connection speeds installation without threading
  • 45-degree street elbow redirects flow in tight spaces
  • 304 stainless steel body resists corrosion in non-potable systems
  • FKM O-ring seals reliably up to 200 psi operating pressure
  • 1/2 inch press-to-FTG sizing fits standard copper tube dimensions

Viega MegaPress 45° Street Elbow

The Viega MegaPress 45° street elbow joins two half-inch stainless-steel pipes at a forty-five-degree angle using a press-fit connection on one end and a fitting connection on the other. It is built for non-potable water systems where corrosion resistance and a secure mechanical joint are required.

Sustained-pressure performance

The fitting is rated for a maximum operating pressure of 200 psi, so it maintains its seal continuously under normal system pressure without relying on a short-term burst rating. Grade 304 stainless steel and an FKM O-ring resist degradation from temperature cycles and chemical exposure over long service intervals.

Press-fit interface limits

The press-fit end requires a compatible press tool and jaw set to form a permanent joint; it cannot be disassembled or reused once crimped. The fitting end accepts a half-inch copper tube stub, so the installer must ensure the mating tube meets the correct outside diameter and wall thickness for a leak-free fit.

Highlights

  • Press-fit connection speeds installation without threading
  • 45-degree street elbow redirects flow in tight spaces
  • 304 stainless steel body resists corrosion in non-potable systems
  • FKM O-ring seals reliably up to 200 psi operating pressure
  • 1/2 inch press-to-FTG sizing fits standard copper tube dimensions

Specifications

BrandViega
MaterialHAWA

Questions about this item

Does the FKM O-ring on the 95080 handle continuous 200 psi pressure without heat-related degradation?

The FKM O-ring material is rated for the fitting's maximum operating pressure of 200 psi in non-potable water applications.

Which press tool and jaw profile are required to install the 1/2" press-fit end on the 95080?

A compatible press tool with the correct jaw profile for 1/2" stainless steel press-fit connections is needed.

Can the 304 stainless steel street elbow join directly to older copper pipe of the same 1/2" size?

The FTG end accepts 1/2" copper tube size, allowing direct connection to existing copper piping.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.