Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00951132BTC
In stock
Viega
Viega MegaPress 45 street elbow 1/2" 26100
A 45-degree steel street elbow with press-fit and FTG connections for 1/2-inch non-potable water lines, rated to 200 psi and 250 Degrees F
- TypeTraffic & Parking Lot
- Press-fit installation saves time on non-potable water lines
- 45-degree street elbow redirects flow in tight spaces
- Zinc nickel-plated steel resists corrosion in harsh environments
- EPDM O-ring seals up to 200 psi working pressure
- Rated for 250 degrees F maximum operating temperature
1/2" 45° MegaPress street elbow
This steel press-fit elbow joins a 1/2" pipe to a 1/2" copper tube at a 45 degree angle. The zinc nickel-plated finish protects the fitting in non-potable water systems. It is built for traffic and parking-lot applications where durable connections are required. The EPDM O-ring seals the joint without threading or soldering.
Thermals noise and power draw
The fitting contains no moving parts, electronics or fluid-moving machinery, so it generates no heat, noise or electrical load. System pressure and temperature are governed by the piping network, not by this component. Normal use adds no measurable thermal or acoustic signature. Maximum operating limits are 200 psi and 250 degrees F.
Press-fit connection and coating
The press-fit ends eliminate the need for thread sealant, solder or open-flame tools during installation. The zinc nickel plating resists corrosion in harsh outdoor environments such as parking lots. The EPDM O-ring material is selected for compatibility with non-potable water service. No separate bolts, gaskets or flanges are required or included.
Highlights
- Press-fit installation saves time on non-potable water lines
- 45-degree street elbow redirects flow in tight spaces
- Zinc nickel-plated steel resists corrosion in harsh environments
- EPDM O-ring seals up to 200 psi working pressure
- Rated for 250 degrees F maximum operating temperature
Specifications
| Brand | VIEGA PROPRESS XL |
|---|---|
| Type | Traffic & Parking Lot |
Questions about this item
How do I press the 1/2" MegaPress street elbow onto the pipe, and what step is often missed?
Cut the steel pipe square, deburr the end, check the EPDM O-ring is seated, mark the insertion depth, then press with a MegaPress XL jaw; the step often missed is verifying the depth mark after pressing.
What maintenance or replacement will the 1/2" MegaPress street elbow need over time?
The zinc nickel-plated steel body and EPDM O-ring are rated for 200 psi and 250 °F; inspect the O-ring during system checks and replace it if it shows cracking or hardening.
At what pressure or temperature limit does the 1/2" MegaPress street elbow reach its rating first under sustained use?
The fitting is rated for a maximum of 200 psi and 250 °F; whichever of those two limits is reached first in your system will govern the service envelope.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
