We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Viega 2915 copper press-fit coupling with centre stop, 1-1/4 inch, EPDM O-rings

Viega

Viega 2915 copper coupling with stop 1-1/4 in

SKU CH-39WK-H5NNV

Copper press-fit coupling joins 1-1/4 in tube with a centre stop and EPDM seal, rated to 200 psi

  • Item Count1
  • Press-fit copper coupling installs without flame or solder
  • EPDM O-ring seal rated for 200 psi potable water
  • Built-in centre stop dimple ensures correct insertion depth
  • Straight 1-1/4 in copper-to-copper joint for clean runs
  • Viega ProPress 2915 system compatibility for reliable press connections

Viega ProPress 2915 Coupling 1-1/4 in

This copper press-fit coupling joins two 1-1/4 inch copper tubes in potable-water systems. The integral centre-stop dimple ensures consistent insertion depth on both ends. EPDM O-rings seal at up to 200 psi operating pressure.

Installers using ProPress tooling.

Plumbers equipped with Viega ProPress jaws can make a permanent joint without flame or solder. The fitting is unsuitable for installers who only have torch and flux equipment or who need a repair coupling without a centre stop.

Press-fit connection method decides fit

The joint is made by a calibrated press tool that compresses the copper body onto the EPDM seal. Without the matching ProPress jaw set the fitting cannot be installed to specification.

Highlights

  • Press-fit copper coupling installs without flame or solder
  • EPDM O-ring seal rated for 200 psi potable water
  • Built-in centre stop dimple ensures correct insertion depth
  • Straight 1-1/4 in copper-to-copper joint for clean runs
  • Viega ProPress 2915 system compatibility for reliable press connections

Specifications

Item Count1
BrandViega

Questions about this item

Will the 1-1/4 in press ends fit my existing 1-1/4 in copper tubing?

Yes, both ends are sized for 1-1/4 in copper tube and use the ProPress press-fit method, so they connect directly to the same-size tubing you already have.

How can I verify the joint is secure after pressing?

The center stop dimple provides a visual depth indicator, and a proper press tool forms a uniform bead around each end; pressure-test the line up to 200 psi to confirm leak-free performance.

Does the box include press jaws or O-ring lubricant?

The package contains only the single copper coupling with its factory-fitted EPDM O-rings; press jaws and any approved lubricant must be purchased separately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.