We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee press fitting with three connections, metallic finish, new condition

Viega

Viega 22228 Reducing Tee Copper Press-Fit 2" 1 1/2" 2

SKU CH-7X42-CDHGG

Copper press-fit reducing tee joins 2 in, 1 1/2 in and 2 in lines for potable water at 200 psi

  • Reducing tee joins 2 in, 1 1/2 in and 2 in copper lines
  • Press-fit ends install fast without soldering or open flame
  • EPDM O-rings seal reliably in potable-water systems
  • Copper body handles up to 200 psi operating pressure
  • Centre-stop dimple ensures correct insertion depth every time

Reducing Tee for Potable Water

The Viega 22228 is a copper press-fit reducing tee designed for potable-water systems. It connects a 2 in run to a 1 1/2 in branch using press-fit connections on all three sides. An EPDM O-ring and centre-stop dimple are included for secure, leak-resistant joints.

Replaces Soldered or Threaded Tees

This fitting replaces traditional soldered or threaded copper tees in new installations or repairs. The press-fit method removes the need for open flame, flux or threading tools, making the upgrade worthwhile when fire permits are difficult or when installation speed is critical.

Sustained Pressure Performance

The fitting is rated for a maximum operating pressure of 200 psi in continuous service. Copper construction and the EPDM seal maintain joint integrity under long-term thermal cycling and pressure fluctuation without the degradation sometimes seen in threaded joints over time.

Highlights

  • Reducing tee joins 2 in, 1 1/2 in and 2 in copper lines
  • Press-fit ends install fast without soldering or open flame
  • EPDM O-rings seal reliably in potable-water systems
  • Copper body handles up to 200 psi operating pressure
  • Centre-stop dimple ensures correct insertion depth every time

Specifications

BrandVIEGA

Questions about this item

What copper tube sizes does the 22228 reducing tee accept?

The tee connects a 2 in press-fit end, a 1 1/2 in press-fit end and another 2 in press-fit end.

Which step is most often missed when pressing the 22228 fitting?

Insert each tube fully until it contacts the centre stop dimple before pressing.

When should the EPDM O-rings on the 22228 tee be inspected or replaced?

Check the O-rings during any system pressure test or if a joint shows signs of leakage.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.